Instructions of Button Operation:
Power button: Press this button, the indicator light shows blue and the
machine starts to work in normal mode with default humidity setting of 60%RH and
low fan speed. The fan starts working and the compressor will begin to work 3 seconds
later..
Press this button again, the compressor stops and the fan will close60 seconds later. All
the indicators light sare off and it enters the standby mode.
Timer button: Press this button to set timing from 0 to 24 hours in
one-hour increments/decrements, along with the Add button and Minus button. When
the machine is running, press this button to set the shutdown time; when it is in the
standby mode, press this button to set the startup time. If users want to cancel time
setting, press the button until it shows 00 on the display.
Add and Minus button: (Timing and humidity setting):
The humidity adjustment is only effective in the normal mode. The initial humidity is
60%. Press these two buttons to programme room humidity from 20% to 80% in 5%
increments or 5% decrease. When the set humidity value reaches at one end, press
again and it will reset to the other end. If the indoor humidity is lower than the set
humidity, the machine stops automatically.
Fan speed button: Press this button to choose low fan speed(sleep) or
high fan speed(turbo).
Mode button: Press this button to choose normal or drying clothes mode.
Air clean button:
Press this button to enter the air clean mode. This function can be activated separately.
It works in a default high fan speed and users can set the timing and fan speed of it.
Press this button again to stop this function, the indicator light is off and fan will stop
60 seconds later.