OROPY 18QJ1204*1/DRLYM Installation guide

Step 1: Adjust the product to the required

width, then make 4 marks through the

gasket holes on the wall by pencil.

Step 2: Punch holes by hand drill (6mm drill

bit) on the marks of the wall (if installing

surface is wood, ignore this step)

Step 3: Put the expansion bolts into the holes (if installing surface is wood, ignore this

step). Place the product on the wall at the correct place, then tighten nuts into the

expansion bolts or tighten nuts into the marked places if the surface is wood by

screw-driver.

Download PDF