2. Toro
  3. Engine Guard Update Kit

Toro Engine Guard Update Kit Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Engine Guard Update Kit Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The Toro Company – 1999
All Rights Reserved
Printed in USA
FORM NO. 3322–680
INSTALLATION
INSTRUCTIONS
PART NO. 100-2517
GTS 200 UPDATE KIT
Loose Parts
Note: Use the chart below to identify parts
used for assembly.
DESCRIPTION QTY.
Engine Guard 1
Bolt 4
Before Installing
POTENTIAL HAZARD
• If you leave the wire on the spark plug,
someone could accidentally start the engine.
WHAT CAN HAPPEN
• Accidental starting of engine could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
• Pull wire off spark plug before you install
kit. Also push wire aside so it does not
accidentally contact spark plug.
1. Disconnect spark plug wire from spark plug.
Installation
1. Remove the four bolts securing the primer guard
and wear plates to the mower housing (Fig. 1).
Discard the four bolts.
2
3
1
Figure 1
1. Primer guard
2. Bolt (4)
3. Wear plate
2. Secure the engine guard, primer guard and wear
plates as shown in Figure 2 with the four new
bolts supplied in this kit.
1
Figure 2
1. Engine guard
/