2. Zebra
  3. ZT211
ZT211

Zebra ZT211 User manual

  • Hello! I've analyzed the provided document, which contains installation instructions for the Zebra ZT211 Platen Roller Maintenance Kit. This guide provides a detailed step-by-step procedure for replacing the printer's platen roller assembly. I am familiar with the safety precautions and the installation steps, so feel free to ask any questions you might have about this maintenance process.
  • What should I do before starting the installation?
    What do I need to verify in the kit before starting?
    What should I do with parts removed during disassembly?
Platen Roller Maintenance Kit
Installation Instructionsfor the ZT211 Printer
Read these instructions thoroughly before installing this kit.
Parts List
Before proceeding, verify that your kit contains the following items. To reorder specific parts, navigate to
zebra.com/parts, and select your printer model.
Platen roller assembly Qty 1
Prepare for Installation
IMPORTANT: Retain all parts removed during disassembly, unless otherwise directed.
NOTE: Observe proper electrostatic safety precautions when handling static-sensitive
components such as circuit boards and printheads.
1. Turn off the printer and disconnect it from the power source.
2. Disconnect all data cables.
3. Open the media cover.
4. Removemedia and ribbon (if used).
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corporation, registered in many
jurisdictions worldwide. All other trademarks are the property of their respective owners. ©2022 Zebra
Technologies Corporation and/or its affiliates. All rights reserved. | zebra.com *P1127843-02EN*
P1127843-02EN Rev A
Replace the Platen Roller
1. Remove the platen roller access cover.
2. Unlock the platen roller bearings by rotating the tabs upward.
3. Lift the platen roller assembly clear of the platen roller housing and remove it from the printer.
2
4. Lower the new platen roller assembly into position.
5. Rotate the tabs to lock the platen bearings.
3
6. Reinstall the platen roller access cover.
Resume Printer Operation
1. Reinstall media and ribbon (if used).
2. Close the printhead assembly.
3. Close the media cover.
4. Reconnect the AC power cord and interface cables.
5. Turn on the printer power.
4
/