2. Dynasty
  3. Electric
Electric

Dynasty Electric Installation guide

  • Hello! I am a chat assistant that has analyzed the provided user manual for DYNASTY Fireplace flame motor removal and installation. The document provides step-by-step instructions on how to safely remove and install the flame motor including guidance on cable management and control board connections. I'm ready to answer any questions you might have about this process.
  • What is the first step in removing the flame motor?
    What needs to be loosened to release the flicker rod?
    How many screws should be removed from the motor?
    Where are the white zip ties located that need to be cut?
    Which cables should be unplugged from controller board?
REMOVAL AND
INSTALLATION GUIDE
D Y N A S T Y F I R E P L A C E
7. Flame Motor
Removal and
Installation
7 - 1 Unscrew the back panel.
7 - 2 Loosen the screws to release the
flicker rod.
7. Flame Motor
Removal and
Installation
7 - 3 Remove 2 screws on the motor
7. Flame Motor
Removal and
Installation
7 - 4 Remove the two screws from
the right side of the panel
which are connected to the
motor.
7. Flame Motor
Removal and
Installation
7 - 5 Carefully cut the two white
zip ties.
7. Flame Motor
Removal and
Installation
7 - 6 Unplug the two red cables
which are connected to "R-N"
and “Motor" from the
control board
"R-N" "MOTOR"
7. Flame Motor
Removal and
Installation
7 - 7 Remove the metal holder from
the motor.
7. Flame Motor
Removal and
Installation
7 - 8 Pull out the motor.
This is the end of the removal step
7. Flame Motor
Removal and
Installation
To put every component back, please follow every signal steps
For the installation guide :
1.
7. Flame Motor Removal and
Installation
Installation guide starts from 7 - 8 to 7 - 1
7 - 8 Put the flicker rod and motor together
7 - 7 Put the motor holder back on
(make sure the wire go through the hole first)
7 - 6 The cables plug into the control board
( make sure one in R-N, other in Motor)
7 - 5 Use zip ties to organize the cables where the two green circle area
(Please check on 7 - 5 Photo)
7. Flame Motor Removal and
Installation
If you still have any questions, please feel free to contact us by phone or
email.
7 - 4 Put the motor back to the right down corner and screws 2 screws to
stabilize (Please look at 7 - 4 photos)
7 - 3 Screw the motor on the holder
(step 7 - 3 photo gonna sure the exact place)
7 - 2 Screw on the flicker rod
7 - 1 Put the back panel on and screw all the screws.
THANK
YOU!!
W W W . D Y N A S T Y F I R E P L A C E S . C O M
V I S I T U S O N O U R W E B S I T E :
/