2. Computers & electronics
  3. Print & Scan
  4. Printing supplies
  5. Printer cleaning
  6. ZOLL
  7. X Series
X Series

ZOLL X Series Operating instructions

  • I have reviewed the provided cleaning instructions for the ZOLL X Series Advanced defibrillator. This document details the proper procedures for cleaning various components of the device using specific cleaning agents. I am ready to answer any questions you have about these instructions, such as the cleaning of cuffs, sensors, cables and print head.
  • What cleaning agents are recommended for the ZOLL X Series Advanced?
    How should NIBP cuffs be cleaned?
    How do I clean the SpO2 sensor?
    How to clean print head?
CLEANING INSTRUCTIONS
Process for Cleaning the ZOLL X Series Advanced
•
Use only the recommended cleaning agents listed below to clean the device.
Follow the directions on the product label for use and storage.
•
DO NOT allow cleaning agent or water to run into the crevices or connector openings
at any time.
•
Always check monitor and connector opening for unusual wear, damage or dampness
while cleaning.
•
Cleaning NIBP Cuffs — Clean the cuffs with common hospital disinfectants, including Clorox®
(1:10 solution), Isopropyl alcohol, Lysol® solution, Phisohex®, Quatricide®, Virex® and
Vesphene®. Wash gently with the solution, then rinse. DO NOT allow solution to enter cuff
tubes. Allow the cuff and hose to completely dry before patient use.
•
Reusable SpO2 Sensors — Disconnect the sensor from the patient cable, if appropriate.
Wipe the entire sensor clean with a 70% isopropyl alcohol moistened pad. Allow the sensor
to dry before returning it to use. Caution: Do not submerge the pulse-oximeter in any cleaning
solution or attempt to sterilize by autoclave, irradiation, steam, gas, ethylene oxide or any
other method. This will seriously damage the pulse co-oximeter.
•
Cleaning Cables and Accessories (including carry case) — Cables, cuff tubing, paddles and
other accessories can be wiped clean with the recommended cleaning agents listed below.
•
Cleaning the Print Head — To clean the recorder print head, perform the following steps:
1. Pull the printer door open, remove any paper.
2. Locate the print head along the front floor of the printer compartment.
3. Gently wipe the print head with a cotton swab moistened with Isopropyl alcohol,
and dry residual alcohol with another dry cotton swab.
4. Place the paper back into the unit and close the cover.
• Refer to the Operator’s Guide for full cleaning and operating instructions.
Products for Cleaning the ZOLL X Series Advanced
•
Sodium Hypochlorite
(Bleach) Solution or Wipes
(up to 10,000 ppm)
•
70% Isopropyl Alcohol
(IPA) Wipes
•
Clinell® Universal Wipes
•
Ethanol Disinfection
with detergent
•
Super Sani-Cloth® Wipes
•
Sani-Cloth Plus® Wipes
•
Oxivir® TB Wipes
•
CaviWipes® XL Wipes
•
Clorox Healthcare
Hydrogen Peroxide Wipes
•
Hydrogen Peroxide Solution
•
Wex-Cide® 128 Solution
•
Coverage Spray HB Plus
•
Bleach Germicidal Wipes
•
Warm Water and Soap
REV A 0420
X Series® Advanced
/