Intellinet IBC-637IR Outdoor Night Vision Megapixel HD Network Bullet Camera, 551366 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Intellinet IBC-637IR Outdoor Night Vision Megapixel HD Network Bullet Camera Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IBC-607IR / IBC-637IR
Network Bullet Camera
Hardware Installation Guide
Package Contents
Camera Network Bullet Camera
Quick Installation Guide
Brief product information and quick
installation
Software CD
IP Surveillance Software
Intelligent IP Installer
User Manuals
Language Packs
Accessories (1) Three-axis wall/ ceiling mounting bracket
(2) Screws and anchors for wall or ceiling
mounting
(3) Sun Shield
(4) Screws for sun shield
(5) Cat 5e Female Coupler
Hardware Description
LED Indication
Power
Steady red during boot up process.
Steady blue after boot sequence has completed.
Flashing purple during firmware upgrade.
Network Flash yellow while Network activity.
MicroSD Card
Steady yellow means MicroSD card ready.
Flash yellow while accessing MicroSD card.
Factory Reset
Reset: With the camera turned on, press the reset button briefly to
reboot the camera, or hold the reset button for 10 seconds to set all
settings back to factory default values.
Hardware Installation
1. Use the two supplied screws to fix the base plate to a flat surface.
2. Loosen the screws on the bracket in order to adjust the camera’s
viewing area.
3. Tighten the screws at the two joints of the bracket to fix the camera
in place.
4. Above: It is recommended to install the network camera in an area where the
camera is not directly exposed to sun light, rain or snow. For example, install the
camera underneath an overhang, such as a roof, to increase the camera’s life
span.
5. Connect the camera via PoE
Using a standard RJ-45 network cable, connect the bullet camera to
an IEEE802.3af/at compliant PoE switch or PoE injector.
6. Connect the camera without PoE
1. Connect the power adaptor to the dome camera
2. Using a standard RJ-45 network cable, connect the camera to a
normal Ethernet Switch or Router
7. Software Installation
Insert the Installation CD into a CD or DVD drive and follow the
instructions given by the Quick Installation Guide.
INTELLINET NETWORK SOLUTIONS™ offers a complete line
of active and passive networking products.
Ask your local computer dealer for more information or visit
www.intellinet-network.com
Copyright © INTELLINET NETWORK
SOLUTIONS
All products mentioned are trademarks or registered trademarks of their respective
owners.
/