For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
MODEL T27337
OPTIONAL BRACKET FOR T27313
INSTRUCTIONS
For Machines Mfd. Since 04/15
COPYRIGHT © JULY, 2017 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL19103 PRINTED IN CHINA
Introduction
The T27337 bracket is used to mount the T27313
Copy Attachment 90 degrees to the G0733 lathe
bed for plate and bowl turning (see Figure 1).
Installation requires components from the T27313.
Description Qty
Additional Person for Assistance....................... 1
Open-End Wrench 17mm
.................................. 1
M8-1.25 x 150 Carriage Bolts (From T27313)
... 2
Fender Washers 8mm (From T27313)
.............. 2
Knobs M8-1.25 (From T27313)
.......................... 2
Support Arm Clamping Plates (From T27313)
.. 2
T-Bolts M10-1.5 x 45 (From T27313)
................. 2
Flat Washers 10mm (From T27313)
.................. 2
Hex Nuts M10-1.5 (From T27313)
...................... 2
Items Needed for Installation
V1.07.17
Installation
1. DISCONNECT MACHINE FROM POWER!
2. Place bracket on lathe bed (see Figure 2).
3.
Insert (2) M8-1.25 x 150 carriage bolts
through lower mounting holes, and install (2)
support arm clamping plates with (2) 8mm
fender washers, and (2) M8-1.25 knobs (see
Figure 2). Verify bracket is perpendicular to
lathe bed.
Figure 1. Copy attachment mounted to bracket.
Figure 2. Model T27337 mounted to lathe bed.
Support
Arm
Clamping
Plate
Bracket
M8-1.25 x 150
Carriage Bolt
M8-1.25
Knob
4. Slide (2) M10-1.5 x 45 T-bolts into channel in
bottom of copy attachment (see Figure 3).
5.
Place copy attachment on bracket with
T-bolts going through upper mounting holes
on bracket. Make sure arbor and cutting tool
on copy attachment face lathe headstock,
and secure with (2) 10mm flat washers and
(2) M10-1.5 hex nuts (see Figure 3).
Figure 3. T-Bolt (1 of 2) installed into copy
attachment and bracket.
Channel
M10-1.5 x 45
T-Bolt
10mm Flat Washer
& M10-1.5 Hex Nut
8mm Fender
Washer
T27337
Bracket
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Grizzly T27313 User manual
-
Grizzly Industrial G0842 Owner's manual
-
-
-
-
-
-
-
-
