2. Rane
  3. FT 45

Rane FT 45 User manual

  • Hello! I am an AI chatbot trained to assist you with the Rane FT 45 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
FT 45
CROSSFADER
10024
2. Remove the four screws securing the
cover plate (see Figure 1) with a #1
3. Carefully remove cover plate.
4. Remove the two mounting screws (shown
in Figure 2) with a #1 screwdriver,
while holding the fader in place.
5. Slide fader to one side and bring through
hole in panel.
6. Remove ribbon cable from the fader
Fader Removal
supplied with the replacement
5. Install the four new mounting screws
with the replacement fader. (see
2. Feed replacement fader through hole.
1. Plug ribbon cable onto fader assembly.
3. While holding fader in place, install
Fader Installation
the two mounting screws supplied
Phillips screwdriver.
assembly.
fader. (see Figure 1).
4. Carefully place the cover plate back
onto unit.
Figure 2)
1. Remove the three fader knobs by
gently pulling up.
6. Place the three knobs back onto the
faders.
Figure 1
102401
Figure 2
TTM 54 PERFORMANCE MIXER
/