Vision grills VGK-NPAK-S1 Operating instructions

Category
Barbecues & grills
Type
Operating instructions
Visit
www.visiongrills.com/register
to register your grill and
view frequently asked questions
• Attach the two hose brackets (used to hold
gas hose), with eyelets facing in, onto the
front and rear legs of cart (Step 1).
Note: Do NOT allow the hose to touch
the ceramic.
STEP 1
Watch For Bubbles
*Leak Test:
Pour Leak Test Solution (not included)
or soapy water at the connection spot
of the gas cylinder to check whether
there is gas leakage. If solution produces
bubbles this means there is a leak.
PARTS
Step 1: Attach Hose Brackets
PART NAMES PART NUMBERS
1 Infrared Heat Exchanger
2 Gas Grill Burner Insert
2.1 Gas Grill Burner Insert Knob
2.2 Ignition Button Cap
3 Gas Hose with Quick
Disconnect Fitting
4 Gas Supply Hose Bracket (x2)
5 Lava Stone
6 SS Stone Bracket
VGC GPIHE
VGC GPBI-S
VGC GPBIK
VGC GPIBC
VGC GHQD1
VGC GPGSLC-2
VGK-101R
VGK-BRACKET
• Remove Ignition Button Cap by
turning counter clockwise. Insert
AA battery (not included) negative
end first.
• Replace Ignition Button Cap by
tightening clockwise.
• Press Red Ignition Button and hold
in to test battery. This will create
spark on burner for starting (See
manual for starting operation).
WARNING: To avoid shock, do not touch spark on burner
Step 2: Install Battery
STEP 2
+
SET UP
ENGLISH
KAMADO Quickchange Natural Gas Insert
for S-Series
Kamado Grills
Model # VGK-NPAK-S1
Patent Pending
5
1
2
2.1
4
6
2.2
3
• From rear of grill, feed gas hose through
eyelets of the hose brackets, grill
connector first. Connect gas hose to the
Gas Insert using the Quick Disconnect
fitting.
• Make sure the gas valve is closed.
Inspect valve connections, port, hose and regulator assembly for any
damage or debris. Remove any debris.
• After the gas hose is connected to the gas source and Gas
Insert, open valve from gas source and use a leak test to test the
connections.
Step 3: Connect to Gas Source
Using the Quick Connect fitting on the Gas Supply
Hose, pull back spring-loaded locking ring and
slide over male connection.
Once it has snapped into place, give slight tug on
gas line to ensure that it is securely connected.
Turn valve on gas source to Open position.
STEP 3
Lock Top Vent
Turn Cast Iron Top Vent to position 3. Turn locking pin
counter clockwise until it drops down in place, keeping
the Top Vent fully open.
WARNING: When using Quickchange Gas Insert, Top Vent must be
locked open to position 3 at all times.
  • Page 1 1

Vision grills VGK-NPAK-S1 Operating instructions

Category
Barbecues & grills
Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI