ASSEMBLY INSTRUCTION
Parts:
Assembly Instructions:
Step 1. Lay out all parts on a soft and clean surface.
Step 2. Place the Basin (A) on a horizontal surface.
Step 3. Put Flower (C) through Fairy (B) hands and feet.
Step 4. Place pump (E) into the empty cavity on the basin (B), letting the pump cord go through the back of the
basin. Carefully holding the Fairy and flower, put the tube through hole in front of basin connect tube to pump (E) in
basin.
Step 5. Place the Fairy (B) on the Basin (A) properly.
Step 6. Put Wings (D) on the back of the Fairy (B).
Step 7. Fill the basin with clean water up to 90% capacity.
Step 8. Connect the pump (C) to your power source and adjust the pump as desired.
WARNING: Risk Of Electric Shock –This Pump Is Supplied With A Grounding Conductor And Grounding-Type
Attachment Plug. To Reduce The Risk Of Electric Shock, Be Certain That It Is Connected Only to A Properly
Grounded, Grounding-Type Receptacle.
IMPORTANT:
MAKE SURE that there is enough water inside the basin before starting the pump. DO NOT let the pump run dry.
If the pump does not discharge water immediately please wait for a few minutes, as there might be air in the
system.
Thank you for choosing Sunnydaze Decor. If you have any questions, comments or concerns feel free to contact us
www.SerenityHealth.com/contact-us
We stand behind our brand and the quality of the items we sell. We will send new parts, or replace products at our
discretion within the one-year warranty period. Before we can help, you will need to provide proof of purchase with the
date of purchase and photos of the defective merchandise. We will use the photos to determine the cause of defect
and for future quality control.
No.
Parts
Qty.
A
Basin
1
B
Fairy
1
C
Flower
1
D
Wings
2
E
Pump
1
/
