OMUR OM820006 User manual

Brand
OMUR
Model
OM820006
Type
User manual
Unique Click System
for 15/64” to 5/8” thick flooring
Combo Pack Parts
Tool Kit
Parts
Equipment needed for installation
Vertical plank installation
Horizontal plank installation
Standard Orientation Planks
Standard Alternative
Standard Orientation Planks
“Left to Right?” or “Top to Bottom?”
W
11-3/4”
3/8” (1cm)
3/8” (1cm)
3/8” (1cm)
3/8” (1cm)
3/8” (1cm)
3/8”
(1cm)
2” (5cm)
2” (5cm)
1-1/2”
(4cm)
1-1/2”
(4cm)
2” (5cm)
3/8” (1cm)
20” (50cm)
20” (50cm)
3/8” (1cm)
1/4” (6mm) 1/4” (6mm)
Spacers
Drill bit must match anchor size
W
Mounting
Rail
Adhesive
Pads
Clip
Wrench
Drill Guide/
Plank Holder
Finish
Razor
Start/Stop
Clips
Connection
Clips
Instructions show vertical plank installation. For horizontal plank installation, work from bottom to top.
Mounting rails should be set equal distance apart (between
12 – 20 inches). Spacing between rails will vary depending
on height (vertical plank installation) or width (horizontal
plank installation) of wall.
Warning! Do not use adhesive pads as the sole means of securing rails
to the wall. Rails must be fastened using screws and wall anchors.
Drill guides are used to install screws for securing
rails to the wall. The screws should be installed at ends and
then at a distance equal to twice
the width of the plank (2 x W).
To determine starting
point and installation
direction:
Look at your chosen planks
and locate the orientation
of the “groove” side.
Standard orientation
installation is shown at left.
Alternative orientation
installs from the opposite
side.
Use adhesive pads to hold rails
on the wall during assembly.
2xW 2xW 2xW 2xW
W
Rev. date 1/9/19
PAGE 1
Vertical plank installation
Horizontal plank installation
Adhere first plank to adhesive pads
and lock in place with Plank Holder
3/8” (1cm)
Cut tongue off
first planks.
Use spacers to space 3/8” (1cm) from floor & wall
Make sure planks stay plumb or
level throughout installation.
PAGE 2
Use drill guide to hold planks in
place during installation.
Do not allow gaps behind planks
Install start/stop clip then
add adhesive pads.
Ensure the
back sides
of all
planks are
free of dust
and debris.
Groove
sides of
planks
must be
placed
facing the
correct
direction,
ready to
interlock
with the
next
plank.
Install connection clips after each plank to secure planks to
every rail, so planks do not come loose or buckle.
NOTE: Groove side of plank orientation - See page 1
Make sure planks are flush against rails.
When finished installing all planks,
use finish razor to remove the
exposed portion of each tab.
  • Page 1 1
  • Page 2 2

OMUR OM820006 User manual

Brand
OMUR
Model
OM820006
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents