Programme Chart and Quick Reference Card
EN
* Values declared on the product or in the operating instruction booklet / programme chart and quick reference card supplied
with the product are obtained in tests performed under controlled laboratory conditions and these tests are as defined in relevant
standards
** Reference programme for the Testing Institute and energy labeling.
How to change the washing programme
To change the programme selection while the machine is operating:
Press start/stop button. The washing light will go off.
Select the new programme. Press start/stop button. The washing light will be on and new programme
will start.
! Important: The new programme will NOT right from the beginning. It will start from the stage last
carried out by the previous programme selection.
Programme Chart and Quick Reference Card
EN
Detergent
compartment
A=25 cm³ /
15 cm³
B=5 cm³
programme
sequence
Consumption
figures
Water (Liter)
Energy (kWh)
Duration (min)
Programme
symbols and
temperatures
Testing program: Eco 50°C as compliant to EN 50242 international norms.
A+B
Intensive
70°C
Heavily
soiled dishes
that have
been kept in
the machine
OR Heavily
soiled dishes
requiring pre-
wash.
A+B
60 °C wash
Cold rinse
Hot rinse
Drying
Prewash
Normal
60°C
Soiled
dishes that
have been
kept in the
machine
Soiled
dishes that
have been
kept in the
machine
A
50 °C wash
Cold rinse
Hot rinse
Drying
Prewash
Eco
50°C
A
35 °C wash
Cold rinse
Hot rinse
Drying
30 min.
35°C
Glasses,
lightly soiled
dishes and
short
programme
-
Prewash
For rinsing
dishes that
will not be
washed
immediately
Operating the dishwasher
Turn the tap on. Open the door of the machine.
Push in the on/off button and check that the indicator light comes on.
Check the salt and rinse aid level indicators before you start the machine. If
necessary add salt and rinse aid.
Check that the upper and lower spray arms can rotate freely. Pour (Put in) the
detergent.
Close the door of the machine.
Press start / stop button and check that the washing light comes on.
Care must be taken if opening the door, as steam and water will escape.
Press the on/off button after the programme is completed. The on/off indicator
light will go off.
Turn of the water tap, unload the baskets.
Do not open the dishwasher door whilst the appliance is in operation. However,
in case the door is opened while the machine is working, then a safety mechanism
ensures the machine immediately stops. Water may be very hot, so be careful.
!
Select the required programme by referring to the programme chart. Select the
desired programme by turning the knob. Do not force the knob.
Stop
Prewash
The programme sequence throughout the washing process can be monitored
from the progress indicator lights on the control panel.
Programme Sequence
Following the washing stage, in order to drain and remove water from inside
the machine completely, the machine will pause for approximately 35 minutes.
Do not worry this is not a fault. Then End progress indicator light will come
on.
Do not switch the machine off before End light comes on.
70 °C wash
Cold rinse
50 °C rinse
Hot rinse
50°C Prewash
Drying
How to cancel the washing programme
To cancel a programme while the machine is operating:
Press start/stop button for 5 seconds. The machine will drain the water inside the machine for 45
seconds. The programme is cancelled when washing light goes off. Then, you can choose and
start a new programme.
! Important: Depending on the stage of the programme you have cancelled, there may be detergent
residue or rinse aid inside the machine and on the load. Make sure the items in the dishwasher are
not used before washing properly.
10,2
0,75
30
3,6
-
15
13
1,01
140
13,2
1,02
96
17,5
1,65
115
On/Off
indicator light
Salt indicator
On / Off Button
17 2238 01 00-00
Washing
Progress
indicator lights
End
Start/Stop Button