YMain points in brief
Mai n poi nt s in br i ef
To adjust the basic settings:
1. Set the programme Baumwolle (Cottons) to
position 1. The appliance is switched on.
2. Press the A button and, at the same time, turn the
programme selector clockwise to position 2.
Release the A button.
Setting mode is now activated.
3. Now you can use the Fertig in (Ready in) button to
change the settings in the basic settings to the
following positions:
– 2: Notification signals: 0, 1, 2, 3, 4 (0 = off, 1 =
quiet, 2 = medium, 3 = loud, 4 = very loud)
– 3: Button signals: 0, 1, 2, 3, 4 (0 = off, 1 = quiet, 2
= medium, 3 = loud, 4 = very loud)
To exit and save the settings, turn the programme
selector to Aus (Off).
;
( Programme selector:
■ For setting a programme and
■ For switching the appliance on and off via the
Aus (Off) position.
0 Adjust Spin speed.
8 Adjust Fertig in (Ready in).
@ Childproof lock (E 3 Sec.)
To activate and deactivate, press and hold the
Spin speed and Fertig in (Ready in) buttons at
the same time for approx. 3 seconds. The
activated childproof lock is indicated on the
display panel by the E symbol. If when the
childproof lock is active, the programme selector
has been turned or a button has been pressed,
the E symbol flashes briefly.
H Additional programme settings:
■ Speed / Eco Perfect: Washing in a shorter
time/energy-saving washing
P A button for:
■ Starting a programme
■ Interrupting a programme, e.g. to add items
of laundry
■ Cancelling a programme
X Display panel for settings and information
3RVLWLRQV
Faults Cause/remedial action, additional information in the instruction manual
The appliance is not filling with water.
Detergent is not being dispensed.
■ Tap turned on? Open the tap.
■ Could the water inflow filter be blocked? Clean the water inflow filter.
The door cannot be opened. ■ If the water level is too high or the detergent solution is too hot, it is not possible to add more
laundry.
■ Is the E childproof lock activated? Deactivate the childproof lock.
■ - - - - = Rinse Stop (without final spin) set? Continue the programme, set a speed or the
Abpumpen (Drain) programme.
The detergent solution is not being pumped
out. /
Display "E:18"
■ Drain pump is blocked. Clean the drain pump.
■ Drain pipe or outlet hose is blocked. Clean the water outlet.
Spin results not satisfactory.
Laundry is wet/too damp.
■ Not a fault – the unbalanced load detection system has cancelled the spin cycle because the
laundry is unevenly distributed. Wash small and large items of laundry together.
■ Too low speed selected? Set a higher speed.
■ Where applicable, run the Schleudern (Spin) programme.
Foam may be leaking from the detergent
drawer.
Have you used too much detergent? Use less detergent in the next wash cycle.
You can find further information about faults, their possible causes and corrective in the instruction manual.