b) When the switch is on HOT, the red light will turn on, indicating the unit is
heating.
NOTE: When switching between COLD and HOT, set the unit at OFF for five
minutes.
5) To set the temperature:
a) For cooling, press COLD once. The temperature range is 39-82°F. However,
the unit can only cool 25°F below the surrounding temperature. For heating,
press HOT once. The temperature range is 86-126°F.
b) When the temperature is blinking, press the up and down buttons to select
the desired temperature.
c) The display shows the current temperature. Once selected, the wine cooler
will begin cooling/heating to the set temperature.
6) To change the display from Celsius to Fahrenheit, or Fahrenheit to Celsius, hold
the up button for 2 seconds.
7) Unplug the wine cooler when not in use.
Maintenance
1) Set the switch on back to OFF. Unplug the unit and let it cool completely.
2) To keep the wine cooler clean, the exterior may be cleaned with a soft, damp
cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with
a soft cloth. CAUTION: Do not let liquid enter the beverage center.
3) Do not use alcohol, gasoline, abrasive powders, furniture polish, or rough
brushes to clean the wine cooler. This may cause damage or deterioration to the
surface of the unit.
4) Do not immerse the wine cooler in water.
5) Wait until the unit is completely dry before use.
Storage
Store the wine cooler in a cool, dry location when not in use. Preferably, to prevent dust
and dirt build-up, use the old packaging to repack the unit.
Troubleshooting
WINE COOLER WILL NOT WORK
1) If using AC adapter, check if the power cord is plugged into an electrical outlet, if
not, plug in. If using DC power cord, confirm that it is plugged into a cigarette
lighter socket.
2) Check if electricity to the main fuse is working.
3) Check if the back switch is on COLD or HOT by confirming that one of the
corresponding indicator lights is on. If back switch is on OFF, change to COLD or
HOT.