Signature Hardware 433262 Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide

This manual is also suitable for

1Cooper Double Robe Hook Installation Instructions
COOPER DOUBLE ROBE HOOK INSTALLATION
TOOLS AND MATERIALS:
We recommend consulting a professional if you are
unfamiliar with installing this type of product. Signa-
ture Hardware accepts no liability for any damage to
the home, product, or for personal injury during
installation.
Unpack and inspect the product for any shipping
damages. If you find damages, do not install. Contact
Customer Relations at 1.866.855.2284.
Observe all local plumbing and building codes.
BEFORE INSTALLING
INSTALLATION
1. Determine a location to mount the robe hook.
2. Hold the mounting bracket against the wall at the desired
location. Make two marks in the slot of the bracket, as the
bracket will require two screws.
3. Set all hardware aside. Drill a pilot hole into the wall at each
marked mounting hole location.
Important: If drilling through tile, you must use a masonry
drill bit to avoid cracking the tile.
4. Insert one of the provided anchors into each of the drilled
holes.
5. Fasten the mounting bracket to the wall using the
provided screws.
6. Install the robe hook onto the mounting bracket. Fasten
the robe hook to the bracket by tightening the set screw
underneath using the provided hex wrench.
Drill
Phillips
Screwdriver
Hex Wrench
Level
Drill Bit
finished wall
anchor
set screw
hex wrench
escutcheon
hole
mounting
bracket
screw
* The above installation diagram is only for reference. While
the design may be different than the actual item, the
installation procedure is the same.
slot
hole
SKU(s): 940979
  • Page 1 1

Signature Hardware 433262 Installation guide

Category
Wall & ceiling mounts accessories
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI