MagnaFlow 19211 Installation guide

Brand
MagnaFlow
Model
19211
Type
Installation guide
Step 1:(Carefully read all instructions before
installation) To detach the OEM Y-Pipe start by
removing the skid plate and the bracket under the
Y-Pipe, Unbolt the flanges at the converters and loosen
the clamp at the rear and remove the Y-Pipe and
muffler assembly. retain the clamp as it will be used to
re-install the muffler assembly.
Step 2: To Prepare the vehicle to accept the Delete
Pipe Measure and mark the OEM Circular Pipe 3.00"
behind the Converter Weld Line shown in Fig. 1.
Step 3: With the Pipe still attached at the Flange cut
at the measured line. Un-bolt the flange and remove
the Circular Pipe from the system.
Step 4: Slip the inlet end of the new Magnaflow
Delete Pipe over the cut converter outlet. Loosely
secure using the supplied clamp.
Step 5: Begin installation of the new Y-Pipe by
slipping the right and left sides together (making sure
the flange is on the P/S pipe) and loosley attaching
using the supplied Band clamp. Keep all clamps and
fasteners loose until final assembly. Attach this Y-Pipe
Assembly to the vehicle using the supplied fasteners.
Re-attach the OEM Pipe and Muffler assemblies as
well as the skid plate and bracket removed earlier.
Step 6: With all components mounted loosely, adjust
the system for clearance of frame & bodywork.
(MAGNAFLOW recommends at least 1/2" of clearance
between the exhaust system and any body panels to
prevent heat-related body damage or fire.)
Step 7: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight to
properly align the pipes and prevent leaks
(Approximately 40ft-lbs). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
19211
2012-2015 Jeep Wrangler 3.6L
Delete / Y-Pipe
Warning: When working on, under, or around any vehicle
exercise caution. Please allow the vehicle's exhaust system
to cool before removal, as exhaust system temperatures
may cause severe burns. If working without a lift, always
consult vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area.
Serious injury or death could occur if safety measures are
not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
19211 12/4/14 REV 000
Converter
Weld Line
Fig. 1
Delete Pipe
D/S Pipe
Assy
2.00" Clamp
Converter
Sheet 1
P/S Pipe
Assy
  • Page 1 1

MagnaFlow 19211 Installation guide

Brand
MagnaFlow
Model
19211
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents