WATER SKI TOW TUBE
Key Code: 42938071
READ THIS INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. FAILURE OR INCORRECT USAGE MAY CAUSE
INJURIES TO HEALTH OR DEATH.
Part List
. Fabric Cover x 1pc
. Tow Tube x 1pc
. Repair Patch x 2pc
. Repair Glue x 1bottle
Inflation and set up
1. Spread out the tow tube and fabric cover.
2. Put the tow tube inside the fabric cover, ensure the valve is kept in line with the hole position of the fabric cover.
3. To inflate the tow tube, open the lid of air valve. Use an air pump（not included）to inflate through the valve,
screw the lid to the valve firmly after fully inflated.
Note: Don’t over-inflate the tow tube.
Don’t use high-pressure pump to inflate.
Recommended the inflation pressure is 6kpa.
4. Tow rope attachment direction: Rope must be threaded to work correctly. Loop end of rope must go through
hole prior to wrapping loop around cleat. Please reference below images.
Repair Instruction
If the tow tube is damaged, use the provided repair kit.
1. Completely deflate the tow tube.
2. Clean the damaged area and let it dry completely.
3. Apply the glue on the surface evenly, press the patch over the area to be repaired and smooth out any air bubbles.
4. Wait 20 minutes before inflation.
Safety Instruction
1. Inspect molded tow piece prior to each use. If it shows signs of damage, cracking or breaking. Do not use.
2. Always wear a properly fitted life jacket before use.
3. Use a tow rope of at least 680kg average tensile strength for pulling a single person. The tow rope should be at
least 15.0m in length but not exceed 19.5m in length.
4. Never exceed 32km/h for adults, 24km/h for children.
5. The maximum number of riders is 1 person, and the maximum loading weight is 100kg.
6. Only use this product with a responsible boat/watercraft operator who knows how to effectively operate the
equipment.
7. This product should be used in water only. Don’t use near piling, docks, shores or shallow water or other
obstructions that could cause serious injury to rider.
8. This product is not a personal flotation device. Don’t use as a life saving device.
9. Children is in competent supervision when using this product.
10. Never get near the propeller with the engine running, even if it is in neutral.
11. Don’t strap or attach arms or legs to cover or tube. Never place hands or feet in between the tube and cover.
Care and Store Instruction
1. To deflate, simply unscrew the entire valve from the base.
2. You may clean your tow tube using soap and water or mild detergent and then allow it to dry enough.
3. Don’t place near open flames and hot sources.
4. Store in a dry and ventilated area out of direct sunlight.
FOR AU/NZ: IMPORTED FOR KMART STORES IN AUSTRALIA AND NEW ZEALAND.
Made in China
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Coleman Inflatable Towable Owner's manual
-
Aquaglide BRAVO Owner's manual
-
O'Rageous Wake Craze II Owner's manual
-
SAFEQUIP ResQcraf 500 Operation & Maintenance Manual
-
SereneLife SLBBFL4 User guide
-
Big Sky Carvers WS100Y19009 User manual
-
Sea Eagle 12.6SR Operating instructions
-
Big Sky Carvers WS100Y19008 User manual
-
MD Sports WS100Y19011 User manual
-
