English 19
Operation
Initial cleaning
Wipe the ceramic glass surface with a damp cloth and ceramic cooktop glass
cleaner.
WARNING
Do not use caustic or abrasive cleaners. The surface could be damaged.
Digital display
• to , selected heat settings
• Residual heat (Still Hot)
• Residual heat
• The child lock is activated.
• message. A touch key has been touched and held for more than 8 seconds.
• message. The cooktop has overheated because of abnormal operation.
(Example : An element was turned on with empty cookware on top.)
• The cookware is unsuitable or too small or no cookware has been placed
on the cooking zone.
• message. The power applied to the cooktop is too high or low.
Safety shutoff
• If the cooktop overheats because of abnormal operation, will be displayed
and the cooktop will turn off.
• If cookware is unsuitable or too small or no cookware has been placed on the
cooking zone, will be displayed.
After 30 seconds, the corresponding cooking zone will turn off.
Other reasons why a cooking zone will switch itself off
All cooking zones will switch themselves off if liquid boils over and lands on the
control panel.
The automatic shutoff will also be activated if you place a damp cloth on the
control panel. In both of these instances, you will need to turn the cooktop on
again using the main POWER key after the liquid or the cloth has been removed.
Operation
Switching the appliance on
Turn the cooktop on by touching the
POWER key for approximately 1 second.
NOTE
After you have touched the POWER key to switch on your cooktop, you must select
a cooking zone or element and a power setting within approximately 20 seconds.
Otherwise, the cooktop will switch itself off for safety reasons.
Selecting a cooking zone and power setting
1. To select an element or cooking zone,
touch the ON/OFF key of the zone or
element.
• The digital displays will show .
2. To set or adjust the power level,
run your nger clockwise or
counterclockwise along the surface of
the element or zone control as shown
in the illustration.
• If you do not set a power level
after selecting an element, the
element will turn off automatically
after 10 seconds.
• You can also use the magnetic
knob to control the element or
cooking zone.
See page 18.