Front Load
Washing Machine
7.0kg Capacity
Getting Started...
For more information please call 1300 11 43 57 WWW.SOLT.HOUSE ESSENTIALS FOR LIFE
Preparing for first use
Calibration
Drum Clean
• Before washing, please ensure that the
transport bolts are removed from the rear of
the machine and that it is installed correctly
following the instructions on page 8 of the
user manual.
• Operate the washing machine for one full
Cotton cycle at 90° C without clothes inside to
ensure that the drum is as clean as possible.
• It’s recommended to calibrate the machine,
to ensure optimal performance.
• Remove all accessories from the drum and
close the door;
• Insert the mains plug to the socket;
• Switch on the washing machine, and within
10 seconds, press “Delay” and “Temp.”
simultaneously for approximately 3 seconds
until “t19” is displayed on the display.
• Press the Start/Pause to start the appliance,
initially“---” is displayed, and then “***”
(such as “126”) is displayed to indicate the real
time drum speed. When the number reaches
a certain value (and stop changing), it means
the washing machine is successfully calibrated.
After 25 washes, the Drum Clean light will
illuminate to remind you to run this cycle.
This program provides a 90°C high temperature
sterilisation cycle to clean the drum and tube.
When this procedure is performed, clothes
or other items should not be added. Use this
program regularly according to your needs.
To cancel the reminder for another 25 cycles,
press and hold the Drum Clean button for
3 seconds.
1 Press ‘On/Off’ to power on your front load
washing machine.
2 Select your desired washing cycle by turning
the Program Selection Dial.
3 Select your preferred washing options
using the additional function buttons on
the right hand side panel (should you wish
to select options different from the default
cycle settings).
4 Touch the ‘Start/Pause’ button to start
the cycle.
For detailed Operating Instructions, refer to
pages 14–19 of your user manual.
Operating the Washing Machine
MODEL
GGSFLW700