17
Appliance maintenance and ordering spare parts
4 Appliance maintenance and ordering spare parts
Emptying and cleaning the dust container
The dust container can only hold a limited quantity of dirt.
It is therefore best to empty the dust container after every cleaning procedure.
1. Make sure that the appliance is switched off and is not on charge.
2. Remove the hand-held vacuum from the appliance, see chapter „Use as a hand-held vacuum“.
3. Unlatch the dust container and remove the filters.
4. Empty the dust container and clean the filters if necessary.
For further information, see also illustrated quick start guide
Troubleshooting by yourself
So that as few problems as possible arise, it is important to empty the dust container regularly and
to take this opportunity to check the filters and clean them if they are dirty.
If you can not solve the problem using the table above, call our
Service hotline (see contact information in the appendix to this in-
struction manual). The motor protection filter, article number
8608048 can be conveniently ordered via the internet under http:/
/www.severin.com/go/to/8364 in the menu "Service/Spare
Parts Shop" or through our customer service department.
Use the QR code on the left to reach our website directly.
Problem Possible cause/Remedy
Appliance can not
be switched on.
Rechargeable battery is completely discharged. Switch off the appliance and
charge rechargeable battery, chapter „Charging the battery and operating
the appliance“.
The appliance
can not be
charged (LED
does not blink).
Mains adapter is not plugged in correctly. Check whether the mains adapter
or adapter plug is seated properly in the outlet (chapter „Charging the bat-
tery and operating the appliance“).
The appliance does not sit correctly on the charger. Place the appliance on
the charger correctly.
The appliance
has lost suction
power.
The dust container must be emptied or the filters must be cleaned, chapter
„Emptying and cleaning the dust container“.
Operating dura-
tion is becoming
ever shorter.
It is possible that dirt is preventing the brush roller from rotating freely. Free
the brush roller of dirt (illustrated quick start guide). If necessary, carefully
use a pair of scissors or tweezers to do this.