HTCTB 123-G
|
Cup Holder Gooseneck Mount for HTC Thunderbolt
™
Smartphone
Package Contents:
(1) GN033-SBH - Gooseneck cup holder mount
(1) CC009-TB - Custom cradle for HTC Thunderbolt smartphone
Note: Mount may not work with adjustable, “pop out” cup holders
or oversize cup holder openings found in full-size pickup trucks.
GN033-G
Gooseneck
cup holder
Always use the cradle with the thumb tab up. Do not rotate the cradle
180° where it may fall off mount head. Do not place mount in or near
an air bag deployment zone or where it will obstruct view of the road.
!
Compatible with:
• HTC Thunderbolt smartphones without protective skins or cases.
CC009-TB
Custom Holder
for Thunderbolt
The Mobile Mounting Specialists™
®
!
Safety Precautions
Follow all manufacturer safety guidelines for operating your device.
Failure to practice safe usage of smartphone device while driving
may result in damage, injury, or death.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in China and Taiwan
© Copyright 2011 Arkon Resources, Inc.
Cup Holder Mounting
D
CLO
S
E
OP
E
N
Connect the gooseneck (A) to the cup holder base (B) by
aligning the groove on the base to the ridge inside the
bottom of the gooseneck.
Place the Cup Holder Mount into a designated cup holder
in the vehicle. Adjust the thumb wheel adjuster (C) to open
or close the cup holder prongs to t in the cup holder.
For oversize cup holder openings or the adjustable “pop
out” cup holders use the optional self-adhesive side sup-
port pads (D). Install the pads by removing the adhesive
backing and placing it on the at surface side of the cup
holder support leg.
Step 1.
Step 2.
Step 3.
(Phone not
included)
HTC Thunderbolt Insertion into Cradle
Step 1. Hold the custom cradle and insert the HTC Thunderbolt
phone device (not included, sold separately) into the cradle
with the thumb tab (E) at the top. The top of the phone
should be rotated to the left when inserted to the cradle.
E
Step 1.
Step 2.
Attach the custom cradle to the dual T-head by inserting
the dual T-tabs (F) into the dual T-slots (G) on the back of
the cradle. Tighten the head angle adjustment ring (H).
Adjust the angle of the ball head by tightening the adjust-
ment wingnut (H).
Attach the Cradle to Mount Pedestal
CLOSE
OPEN
B
A
C
F
H
G
All brand names and product names are trademarks or registered trademarks of their respective owners.
-
1
