Asahi Pentax WG-10 User manual
- Category
- Bridge cameras
- Type
- User manual
2
2
1
1
MENU
Cancel
Date Adjustment
Date Format
mm
/dd/yy
24
h
Date
Time
01/01/2013
00:00
Settings complete
OK
OK
MENU
Cancel
Date Adjustment
Date Format
mm
/dd/yy
24
h
Date
Time
01/01/2013
00:00
Settings complete
MENU
Cancel
City
DST
New York
Hometown
OK
OK
MENU
Cancel
Initial Setting
Hometown
New York
Settings complete
English
DST
OFOFFOFF
MENU
Cancel
Initial Setting
Hometown
New York
Settings complete
English
DST
OFOFFOFF
MENU OK
Cancel OK
38
P
14:21 4 : 2 502/02/'130 2 / 0 2 / ' 1 302/02/'13 14:25
+1.0
1/250
F3.5
DATE
Names of Parts and Monitor Indicators
Checking the Contents of the Package
Preparing the Camera for Use Turning the Camera On
In this Quick Guide,
the arrow keys to
be pressed are
indicated as shown
on the right.
Check that your camera comes complete with
the items listed below.
Macro stand (O-MS1)Strap (O-ST104)
Operating Manual
Quick Guide (this guide)
Software (CD-ROM)
S-SW136
Battery charger (D-BC92) AC plug cord
Rechargeable lithium-ion
battery (D-LI92)
USB cable (I-USB7)
Camera (PENTAX WG-10)
The PENTAX WG-10 is waterproof, dustproof, and
shockproof, as shown below, so you can use it in a wide
range of outdoor activities.
Waterproof/dustproof: JIS grade 8 waterproof and grade 6
dustproof (IP68)
Shockproof: Satisfies PENTAX drop test (1.5 m height
onto a 5 cm thick plywood surface) complying with
MIL-Standard 810F Method 516.5-Shock testing.
* Waterproof performance is not guaranteed if the camera
is exposed to impact such as being dropped or hit.
* The camera is not guaranteed to be free of trouble or
damage under every condition.
Battery Level Indicator
You can check the battery level by the indicator on the display.
Battery Status
Adequate power remains.
Battery is running low.
Battery is running very low.
Battery is exhausted.
The camera turns off after this message appears.
Screen Display
(green)
(green)
(yellow)
(red)
[Battery depleted]
Front
Back
Prepare your camera for use before you begin
using it.
Attach the strap supplied
with the camera as shown
in the illustration.
Install the battery and SD
Memory Card as shown in
the illustration.
Installing the Battery
and SD Memory Card
Attaching the
Strap
* The SD Memory Card is sold separately.
The inside of the battery/card and terminal covers are not waterproof
In locations where the camera is exposed to water or dirt
such as underwater, at the beach, in a kitchen, etc., make
sure that the battery/card and terminal cover lock levers are
firmly locked so that they won't open unexpectedly. Do not
open the covers in such locations.
When removing the battery or card, avoid surroundings where
the camera may be exposed to water or dirt, and make sure the
camera, battery, card, and your hands are completely dry.
Thank you for purchasing this PENTAX digital camera.
Shooting mode
Flash mode
Face Detection
Drive mode Focus mode
Digital zoom icon
Memory status
Built-in memory
(without card)
SD Memory Card
Card is write-protected
Focus frame Date and
time
Date imprint
setting
Eye-Fi communication status
World Time setting
Camera shake
reduction
Aperture
D-Range Setting
Remaining image
storage capacity
EV
compensation
Normal display in the Still Picture Capture Mode
:
No icon Hometown
:
Destination
Shutter speed
Battery level
Monitor Indicators
Following indicators are displayed in the still picture capture mode.
Press the power switch.
3
Continue on the reverse side.
12
Press the four-way controller (
5
) to select [01] (month), [01]
(day) or [2013] (year), then use the four-way controller (
23
)
to set the current date and time.
11
Press the four-way controller (
5
), then press the four-way
controller (
3
) to move the frame to [Date].
10
Use the four-way controller (
45
) to
choose a city.
5
Press the four-way controller (
3
) to
move the frame to [W Hometown].
Press the four-way controller (
5
) to select [24h], then use
the four-way controller (
23
)
to select [24h] (24-hour
display) or [12h] (12-hour display).
Press the four-way controller (
3
) to move the frame to [DST]
(Daylight Saving Time).
6
Use the four-way controller (
45
) to select
O
or
P
and press
the 4 button.
The [Initial Setting] screen reappears.
7
Press the four-way controller (
3
) to select [Settings complete]
and press the 4 button.
The [Date Adjustment] screen appears.
8
Press the four-way controller (
5
).
The [W Hometown] screen appears.
4
13
Press the four-way controller (
5
), then press the four-way
controller (
3
) to move the frame to [Time].
14
Set the time in the same manner as in . Then press the
four-way controller (
5
).
15
12
Make the Initial Settings.
2
Use the four-way controller
(
2345
) to select the desired
language.
The [Language/ ] screen appears when the camera is turned on for
the first time. Select the desired language and then set the date and time.
The camera turns on and is ready to take
still pictures. Press the power switch
again to turn the camera off.
Memo
If you accidentally select the wrong
language and press the 4 button,
press the four-way controller (
5
), use
the four-way controller (
2345
) to
select the desired language, and then
press the 4 button. The [Initial
Setting] screen appears in the selected
language.
1
Press the 4 button.
The [Initial Setting] screen
appears.
Press the four-way controller (
3
)
to select [Settings complete] and
press the 4 button.
9
Press the four-way controller
(
5
) to select [mm/dd/yy], then
use the four-way controller
(
23
) to choose the date
format.
Formatting an SD Memory Card
Use this camera to format (initialize) an SD Memory Card that is
unused or has been used on another camera or digital device.
Be aware that formatting will delete all the data stored in the SD
Memory Card. For how to format an SD Memory Card, refer to
the Operating Manual (p. 214).
Flash
Speaker/Microphone
Lens
Remote control
receiver
Macro light
Shutter release button
Self timer lamp/
Focus assist
Power switch/Power lamp (green)
Battery/card cover
lock lever
Display
Terminal cover
Terminal cover
lock lever
Battery/card cover
PC/AV terminal
HDMI terminal
Battery lock lever
Tripod socket
Battery/card
cover lock lever
SD Memory Card
Battery
Battery/
card cover
Battery
lock lever
SD Memory Card socket
2
3
54
2012/12/14 11:41:28 Illustrator 15.0.2 KB546_QG_EN_Omote_10e.eps
3
3
Printed in Indonesia R01BAA13
54768
Selecting a Playback Mode
4
4
Playing Back Images
Taking Pictures
Selecting the Flash Mode
Each time you press the four-way controller (
4
), the flash mode switches
between the following modes.
Auto
Flash Off
Flash On
Auto + Red-eye
Flash On + Red-eye
Selecting the Drive Mode
Each time you press the four-way controller (
2
), the drive mode switches
between the following modes.
Standard (single-frame)
10 sec. Self-timer
3-sec Remote Control
Press the shutter release button halfway.
The focus frame on the display turns green if the
subject is in focus.
The picture is taken.
Aim the camera at the subject, then press the shut-
ter release button. The flash discharges automati-
cally depending on the brightness.
Frame the subject using the focus frame on the display.
Press the w/xbutton to change the captured area.
You can choose the playback function
you want to use with the Playback
Mode Palette.
For details about how
to use the PENTAX
WG-10 or instructions
on connecting the
camera to a computer,
refer to the manual
below.
Selecting a Shooting Mode
An explanation appears when you select the shooting mode.
Use the four-way controller (
2345
)
to choose a shooting mode, then
press the OK button.
You can choose the right mode for your particular situation
from the Capture Mode Palette.
Press the four-way controller (
3
).
Use the four-way controller (
2345
)
to choose a playback mode, then
press the OK button.
3
2
1
4
Memo
Memo
Memo
Memo
Memo
Selecting the Focus Mode
Each time you press the four-way controller ( ), the focus mode switches
between the following modes.
Standard
Macro
1cm Macro
Pan Focus
Infinity
Manual Focus
For details, refer to the Operating Manual (p.110).
The functions available in Capture mode may be different.
You can select
Z
(2 sec. Self-timer) by pressing the four-way
controller (
3
) and then (
5
) after selecting
g
(10 sec. Self-timer).
You can select
h
(0-sec Remote Control) by pressing the four-way
controller (
3
) and then (
5
) after selecting
i
(3-sec Remote
Control).
For details, refer to the Operating Manual (p.94 - 101).
The functions available in Capture mode may be different.
For details, refer to the Operating Manual (p.108).
Press the four-way controller (
3
) while
an image is displayed in playback mode.
An explanation appears when you
select the playback mode.
Widens the area
that is captured
by the camera
Enlarges
the subject
Press the shutter
release button fully.
The monitor display in 16:9 aspect ratio
When [Recorded Pixels] is set to
i
/ / /
h
in [A Rec. Mode], the aspect ratio of the image is 16:9 and the
monitor display for recording and playback is as shown below.
For details on how to select the Recorded Pixels, refer to the
Operating Manual (p.116).
PENTAX WG-10
Operating Manual
PENTAX RICOH IMAGING CO., LTD.
http://www.pentax.jp
PENTAX RICOH IMAGING DEUTSCHLAND GmbH
http://www.pentax.de
PENTAX RICOH IMAGING UK LTD.
http://www.pentax.co.uk
PENTAX RICOH IMAGING CANADA INC.
http://www.pentax.ca
PENTAX RICOH IMAGING CHINA CO., LTD.
http://www.pentax.com.cn
PENTAX RICOH IMAGING
AMERICAS CORPORATION
http://www.pentaximaging.com
PENTAX RICOH IMAGING FRANCE S.A.S.
(European Headquarters)
HQ
France
http://www.pentax.eu
http://www.pentax.fr
The confirmation screen appears.
Play back the image you want to delete.
Press the
i
button.
2
1
Use the four-way controller (
2
) to select [Delete].
3
Press the OK button.
4
Memo
You can delete several images selected from the 6- or 12-image
display. For details, refer to the Operating Manual (p.167).
You can delete all images at once. For details, refer to the
Operating Manual (p.168).
You can protect stored images from being accidentally deleted.
For details, refer to the Operating Manual (p.169).
100-001100-0017100-0017
Delete
Cancel
OK
OK
OK
OK
You can play back the images taken on the display.
Playing Back Images
The image appears on the display.
Press the
Q
button after taking a picture.
Deleting a Single Image
You can delete the currently displayed image.
Deleting Images
1
To play back the previous or next image, press the four-way
controller (
45
).
Pressing f on the f/y button during playback displays 6
thumbnail images. Pressing f again in 6-image display switches
to 12-image display. Pressing f yet again switches to folder or
calendar display. For details, refer to the Operating Manual
(p.153).
Memo
101 0 0
-
0030 0 3 8100
-
0038
Edit
3 838
P
Landscape
For capturing landscape
views. Enhances colors
of sky and foliage
1/2
OK
OK
MENU
Cancel
1/2
OK
OK
MENU
Cancel
Slideshow
For continuously playing
back images. Screen or
sound effects can be set
F4.6
1/250
38
2012/12/18 10:52:43 Illustrator 15.0.2 KB546_QG_EN_Ura_CS5e.eps
-
1
-
2
Asahi Pentax WG-10 User manual
- Category
- Bridge cameras
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
