Lyric Speakers LS6.5S Installation guide

Type
Installation guide
Installation Instructions
PREPARATION FOR INSTALLATION INSTALLATION
Pre-wire or Pre-construction
Locate all obstructions (AC wiring, plumbing, duct work, studs, and joists).
Route the speaker wire to the speaker location avoiding all obstacles.
Lyric Speakers offers New Construction Brackets (Rough-In Brackets) that can
be fastened to the adjacent studs. Once the dry wall is installed, the opening
is cut out. There are tie-off molded into the bracket for speaker wire tie-off to
keep the wire from being lost during construction.
Retrofit Installation
Locate existing pipes, duct work, and AC wiring before cutting any holes in the
ceiling.
1. Center the cardboard template between adjacent joists, avoiding all wiring,
pipes, duct work, and lightly mark the outline with a pencil.
2. Cut the hole with the appropriate tool.
Note:
Run four-conductor wiring
for dual tweeter speakers.
Rough-in Bracket
Speaker Cable
Stud / Joist
Trace around the template Cut out the opening
Cut-out
Template
Cut-out
Template
1. Connect the speaker wire to the speaker terminals:
Leave about 2' (60 cm) of wire extending through the ceiling cut-out.
Pull the conductors apart so the last two inches are separated and remove
1/2" (13 mm) of insulation from the end of each conductor.
Twist the strands in each conductor into tight spirals.
Attach the speaker wires to the red and black speaker terminals. Connect
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire are
touching the other conductor or terminal.
Dual Tweeter speakers have four terminals; Right(+), (-) and Left(+), (-).
Run an extra pair of conductors and observe proper polarity when making
connections.
2. Center the speaker in the cutout. Rotate the frame as needed before
tightening the screws. Tighten the screws equally until the clamps secure the
frame. Do not overtighten.
3. Attach the magnetic grille.
Insertion of speaker wire on
back of speaker baffle
Install Speaker
Speaker
Speaker
Magnetic Grille
Magnetic
Grille
As screws are
tightened, clamp
will rotate out and
snug against the
drywall.
Cutout
Clamp
3 Mounting screws
Speaker
Cable
+
Technical Specifications
Model Woofer Tweeter Impedance Sensitivity
Frequency
Response
Recommended
Power
Overall
Dimensions
Cut-out
Dimensions
Mounting
Depth
LS6.5S
6.5" (16.51 cm)
Polypropylene cone
w/NBR surround
3/4" (1.91 cm)
Pivoting
PEI dome
8 ohms
88dB
@ 1w/1m
50Hz - 20kHz 5 - 80 watts
9.13" dia.
(23.19 cm)
8.375" dia.
(21.27 cm)
3.49"
(8.86 cm)
LS6.5P
6.5" (16.51 cm)
Polypropylene cone
w/NBR surround
1" (2.54 cm)
Pivoting
silk dome
8 ohms
90dB
@ 1w/1m
50Hz - 20kHz 5 - 90 watts
9.13" dia.
(23.19 cm)
8.375" dia.
(21.27 cm)
3.49"
(8.86 cm)
LS6.5DT
6.5" (16.51 cm)
IMPP/carbon fiber
cone
w/NBR surround
2 x 3/4"
(1.91 cm)
silk dome
8 ohms
90dB
@ 1w/1m
40Hz - 20kHz
8 - 120 watts
(total)
9.13" dia.
(23.19 cm)
8.375" dia.
(21.27 cm)
3.69"
(9.37 cm)
LS8S
8" (20.32 cm)
Polypropylene cone
w/NBR surround
3/4" (1.91 cm)
Pivoting
silk dome
8 ohms
90dB
@ 1w/1m
35Hz - 20kHz 5 - 100 watts
10.63" dia.
(27 cm)
9.875" dia.
(25 cm)
3.98"
(10.1 cm)
©2015 Lyric Speakers
WARRANTY STATEMENT LYRIC LOUDSPEAKERS.
Lyric loudspeakers and accessories are covered by a lifetime warranty in respect to manufacturing and
equipment defects. Other claims are not covered. This warranty is a national warranty in accordance with
relevant legislation. Period of the warranty is as stated below and is in effect from the date of purchase.
Customer sales slip with date of purchase is the only document needed for warranty claims.
Lyric in ceiling and in wall loudspeakers carry a limited LIFETIME WARRANTY.
Lyric loudspeakers warrant to the original retail purchaser only that the Lyric products will be free from
defects in materials and workmanship, provided the speaker was purchased form an authorized Lyric dealer.
Defective products must be shipped, together with proof of purchase, prepaid insured to an authorized Lyric
custom integrator or authorized dealer from whom the product was purchased or installed.
It is preferable to ship this product in the original shipping container to lessen the chance of transit damage.
In any case the risk of loss or damage in transit is to be borne by the purchaser. If, upon examination at Lyric
or the Lyric Authorized dealer, it is determined that the unit was defective in material or workmanship at
any time during this warranty period, Lyric loudspeakers will, at it’s option, repair or replace this product at
no additional charge, except as set forth below. If this model is no longer available and cannot be repaired
effectively, Lyric Loudspeakers, at its sole option, may replace the unit with a current model of equal or
greater value. In some cases where a new model is substituted, a modification of the mounting may be
required. If mounting surface modification is required, Lyric loudspeakers assumed no responsibility for such
modification. All replaced parts and product become the property of Lyric Loudspeakers. Product replaced
or repaired under this warranty will be returned to the original retail purchaser, within a reasonable time,
freight prepaid.
This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse,
negligence, inadequate packing or shipping procedures, commercial use, voltage input in excess of the
rated maximum of the use of the unit, or service, repair or modification of the product which has not be
authorized or approved by Lyric Loudspeakers. This warranty also includes normal cosmetic deterioration
caused by environmental conditions.
This warranty is in lieu of all other expressed warranties. If the product is defective in material or workmanship
as warranted above, the purchaser’s sole remedy shall be repair or replacement as provided above.
  • Page 1 1
  • Page 2 2

Lyric Speakers LS6.5S Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI