Generation Lighting 75952-962 Operating instructions

Brand
Generation Lighting
Model
75952-962
Type
Operating instructions

This manual is also suitable for

Installation Instructions for
Stirling 2 Light Flush Mount
1.0
HC-1726FS
Ceiling
75952_-_
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
3/8”
1A
Secure the mounting plate to the electrical box with two mounting plate screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place using the provided
canopy screws.
Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage information.
Screw the short end of threaded nipple to the bottom of the socket assembly. Ensure that the two locking hex nuts areCAUTION:
snug to each other and placed three-eigths of and inch from one end of the threaded nipple.
Align the shade to the shade mounting plate so the holes on the top of the shade line up with the holes in the shade mounting
plate, then use the thumb screws to secure the shade to the plate.
Place a hex nut, metal washer and rubber washer(in that order) over the threaded nipple.
Place the diffuser onto threaded nipper and secure it in place using remaining rubber washer,
metal washer and hex nut (in that order.) : Over tightening the hex nut may causeCAUTION
the glass to break resulting in injury.
Tighten the finial onto the end of the threaded nipple to cover the hex nut and washer.
1
2
3
4
5
Install the Fixture
MOUNTING PLATE
CANOPY SCREW
SOCKET ASSEMBLY
MOUNTING PLATE SCREW
THREADED NIPPLE
DIFFUSER
FINIAL
RUBBER WASHER
ELECTRICAL BOX
METAL WASHER
RUBBER WASHER
METAL WASHER
HEX NUT
HEX NUT
THUMB SCREW
LOCKING HEX NUTS
CANOPY
LAMP
SHADE MOUNTING PLATE
SHADE
6
7
8
10
9
1
3
1
4
5
10
7
11
8
7
6
11
1
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.SeaGullLighting.com
© 2018 Sea Gull Lighting.All rights reserved.The "Sea Gull Lighting" graphic is a
registered trademark of Sea Gull Lighting. Sea Gull Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVETHESE INSTRUCTIONS!
  • Page 1 1

Generation Lighting 75952-962 Operating instructions

Brand
Generation Lighting
Model
75952-962
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents