Astrium IRITRACK Assembly Instructions

Brand: Astrium

Model: IRITRACK

Category: Security device components

Type: Assembly Instructions

Astrium IRITRACK is a security system and satellite tracking device designed for use on motorcycles and quad bikes. It provides real-time tracking, emergency assistance, and remote monitoring capabilities. IRITRACK utilizes GPS and Iridium satellite communication to transmit data, allowing it to operate even in remote areas without cellular coverage. With its rugged design and IP64 rating, IRITRACK can withstand harsh environmental conditions. The device features a user-friendly interface with accessible buttons for easy operation in emergency situations.

To drive with an Iritrack - security system and satellite tracking - you need a fitting kit for bike/quad including the

power cable and the antenna cables + GPS and Iridium antenna.

The bracket has to be ordered separately: you can install your Iritrack on your bike or quad with several types of

brackets:

KIT COMPOSITION:

1 : Power cable 3 m

2 : Iridium octagonal antenna on a

plate, with a 10 cm cable

3 : Iridium antenna cable 1 m

4 : GPS rectangular antenna on a

plate, with a 10 cm cable

5 : GPS antenna cable 1 m

6 : Shrinkable tube, protect cables,

3 amp fuse.

Bracket to order separately:

Touratech 6-points bracket for Iritrack + GPS on the handlebar Réf. SUPG203+ SUPC204 - ERTF

- Réf. SUPG 203 ERTF - Touratech 6-points bracket for Iritrack

- Réf. SUPC 204 ERTF - Omega module for GPS

Please contact ERTF, c[email protected]

Separate IRITRACK bracket on the navigation column Réf. PR4005 – ASTRIUM

Iritrack assembly with a separate Iritrack bracket on the navigation column

- Réf. PR4005 ASTRIUM – separate Iritrack bracket

- Réf. PR4057 ASTRIUM – silent-blocs, 4 pieces

The separate Iritrack bracket can be mounted

- horizontally (keyboard upwards)

- vertically (keyboard towards the driver)

The keyboard must be accessible and visible for handling in case of emergency.

The bracket must absolutely be fitted with a damping system, PR4057

Technical characteristics of the Iritrack :

- Dimensions of the V2/V2.5 without bracket: 175 mm x 125 mm x 48 mm (without plugs and cables)

- Weight of the box Iritrack: 1.2 Kg

- Environment: Operating from - 30°C to + 55°C and storage from -40°C to +65°C

- Consumption under 12V for Iritrack, 300mA on rest, 1000mA on communications

- IP64 standard - Iritrack is complete protection against dust and water splashing from any direction

ASSEMBLY INSTRUCTIONS

IRITRACK KIT - BIKE/QUAD

MOTO / QUAD

IMPORTANT :

The machine must be presented at the technical

verifications with the bracket, cabling and

antennas mounted, ready to receive the Iritrack

ASTRIUM

DEPARTEMENT RALLYE RAID

–

114/126 Avenue d’Alfortville

–

94600 CHOISY LE ROI

–

Franc

TEL : + 33 (0)1 48 84 34 00 – FAX : + 33 (0)1 48 52 53 54 – email: asbc.rallye@astrium.eads.net – www.astrium.com

Sa au capital de 236 400 € - SIRET 334 306 172 00084 – RC 334 306 172 – code APE 5912 Z

BRACKET

• The bracket can be mounted on

the dashboard. The buttons on the

Iritrack must be visible and

accessible by the pilot in case of

emergency

• It is essential to have sufficient

space in order to move fingers at

the back of the box to check the

connection of the cables: about

10cm.

Iritrack assembly with separate

Iritrack bracket:

The separate Iritrack bracket must

absolutely be fitted with a

damping system

(silent-blocs available on request, réf PR4057

ASTRIUM).

If there is no damping system, a no-

compliance will be declared during the

technical verifications.

EXTENSION OF POWER

• Connect the red wire on the +12 V / +24 V (red terminal) and the black wire to the negative pole of the battery

• Install the 3A fuse on the red wire.

• L’Iritrack must be connected directly to the battery, as required by the FIM regulations (no breaker and no

contact on power).

• Bring power to the bracket

GPS IRITRACK & IRIDIUM ANTENNAS AND CABLES

•

The antenna must be installed in front of the bike / quad

(middle of the front fender, the top of the bubble or the head of instrumentation).

•

It is strongly advised to place plastic collars (type Rislan) to maintain the antennas

• GPS and Iridium antennas can be side by side. They must be installed horizontally and clear of all obstacles at

180 degrees towards the sky. It is forbidden to paint them. Screw the cables from each antenna and bring the

connections to the bracket.

At this stage of the installation you must have at the back of the support

with a margin of 10 cm:

1. Power cable

2. Iridium antenna cable

3. GPS antenna cable

Treat your cable ducts.

• Avoid friction locations.

• It is recommended each day to check the fixings, the wear of

the cables and to tight the connectors

ASTRIUM

DEPARTEMENT RALLYE RAID

–

114/126 Avenue d’Alfortville

–

94600 CHOISY LE ROI

–

France

TEL : + 33 (0)1 48 84 34 00 – FAX : + 33 (0)1 48 52 53 54 – email: asbc.rallye@astrium.eads.net – www.astrium.com

Sa au capital de 236

400

€

SIRET 334 306 172 00084

–

RC 334 306 172

–

code APE 5912 Z

CAUTION

is very important to put

a shrinkable tube on each antenna /

cable to couple them.

Before heating the shrinkable tube,

make sure the connectors are

properly locked.

Mounting with s

eparate

Iritrack

bracket

on the

navigation column

Touratech 6

points

bracket for

Iritrack

with

Omega

GPS bracket

Astrium IRITRACK Assembly Instructions

Brand: Astrium

Model: IRITRACK

Category: Security device components

Type: Assembly Instructions

Download PDF

report

Astrium IRITRACK Assembly Instructions

Astrium IRITRACK Assembly Instructions

Other documents