3
3(5621$/6$)(7<FRQW
6. 'UHVVSURSHUO\'RQRWZHDUORRVHFORWKLQJRUMHZHOOHU\.HHS\RXUKDLUFORWKLQJ
DQGJORYHVDZD\IURPPRYLQJSDUWVLoose clothes, jewellery or long hair can be
caught in moving parts.
7. ,IGHYLFHVDUHSURYLGHGIRUWKHFRQQHFWLRQRIGXVWH[WUDFWLRQDQGFROOHFWLRQIDFLOLWLHV
HQVXUHWKHVHDUHFRQQHFWHGDQGSURSHUO\XVHGUse of dust collection can reduce
dust-related hazards.
POWER TOOL USE AND CARE
1. 'RQRWIRUFHWKHSRZHUWRRO8VHWKHFRUUHFWSRZHUWRROIRU\RXUDSSOLFDWLRQThe
correct power tool will do the job better and safer at the rate for which it was designed.
2. 'RQRWXVHWKHSRZHUWRROLIWKHVZLWFKGRHVQRWWXUQLWRQDQGRIIAny power tool
that cannot be controlled with the switch is dangerous and must be repaired.
3. 'LVFRQQHFWWKHSOXJIURPWKHSRZHUVRXUFHDQGRUWKHEDWWHU\SDFNIURPWKHpower
WRROEHIRUHPDNLQJDQ\DGMXVWPHQWVFKDQJLQJDFFHVVRULHVRUVWRULQJSRZHUWRROV
Such preventive safety measures reduce the risk of starting the power tool accidentally.
4. 6WRUHLGOHSRZHUWRROVRXWRIWKHUHDFKRIFKLOGUHQDQGGRQRWDOORZSHUVRQV
XQIDPLOLDUZLWKWKHSRZHUWRRORUWKHVHLQVWUXFWLRQVWRRSHUDWHWKHSRZHU
WRROPower tools are dangerous in the hands of untrained users.
5. 0DLQWDLQSRZHUWRROV&KHFNIRUPLVDOLJQPHQWRUELQGLQJRIPRYLQJSDUWV
EUHDNDJHRISDUWVDQGDQ\RWKHUFRQGLWLRQWKDWPD\DIIHFWWKHSRZHUWRROV
RSHUDWLRQ,IGDPDJHGKDYHWKHSRZHUWRROUHSDLUHGEHIRUHXVHMany
accidents are caused by poorly maintained power tools.
6. .HHSFXWWLQJWRROVVKDUSDQGFOHDQProperly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
7. 8VHWKHSRZHUWRRODFFHVVRULHVDQGWRROELWVHWFLQDFFRUGDQFHZLWKWKHVH
LQVWUXFWLRQVDQGLQWKHPDQQHULQWHQGHGIRUWKHSDUWLFXODUW\SHRISRZHUWRRO
WDNLQJLQWRDFFRXQWWKHZRUNLQJFRQGLWLRQVDQGWKHZRUNWREHSHUIRUPHG
Use of the power tool for operations different from those intended could result
in a hazardous situation.
BATTERY TOOL USE AND CARE
1. 5HFKDUJHRQO\ZLWKWKHFKDUJHUVSHFLILHGE\WKHPDQXIDFWXUHUA charger
that is suitable for one type of battery pack may create a risk of fire when used
with another battery pack.
2. 8VHSRZHUWRROVRQO\ZLWKVSHFLILFDOO\GHVLJQDWHGEDWWHU\SDFNVUse of
any other battery packs may create a risk of injury and fire.
3. :KHQEDWWHU\SDFNLVQRWLQXVHNHHSLWDZD\IURPRWKHUPHWDOREMHFWVOLNH
SDSHUFOLSVFRLQVNH\VQDLOVVFUHZVRURWKHUVPDOOPHWDOREMHFWVWKDWFDQ
PDNHDFRQQHFWLRQIURPRQHWHUPLQDOWRDQRWKHU Shorting the battery
terminals together may cause burns or a fire.
4.8QGHUDEXVLYHFRQGLWLRQVOLTXLGPD\EHHMHFWHGIURPWKHEDWWHU\DYRLG
FRQWDFWIf contact accidentally occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the battery may cause irritation
or burns.
SERVICE
+DYH\RXUSRZHUWRROVHUYLFHGE\DTXDOLILHGUHSDLUSHUVRQXVLQJRQO\
LGHQWLFDOUHSODFHPHQWSDUWVThis will ensure that the safety of the power tool
is maintained.
GENERAL POWER TOOL SAFETY WARNINGS cont.
SCREWDRIVER SAFETY WARNINGS
GENERAL SAFETY WARNINGS
4
+ROGSRZHUWRROE\LQVXODWHGJULSSLQJVXUIDFHVZKHQSHUIRUPLQJDQRSHUDWLRQZKHUH
WKHIDVWHQHUPD\FRQWDFWKLGGHQZLULQJFasteners contacting a “live” wire may make
exposed metal parts of the power tool “live” and could give the operator an electric shock.
&KDUJHU6DIHW\DQG,QIRUPDWLRQIRUUDGLDWHGHPLVVLRQ
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
· Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL SAFETY WARNINGS
1. Do not use damaged or worn driver bits.
2. Use clamps or a vice to hold workpiece, if possible.
:$51,1*5HDGDOOVDIHW\ZDUQLQJVDQGLQVWUXFWLRQV)DLOXUHWRIROORZWKH
ZDUQLQJVDQGLQVWUXFWLRQVPD\UHVXOWLQHOHFWULFVKRFNILUHDQGRUVHULRXVLQMXU\
!
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
!
1. :$51,1*5LVNRIILUHDQGEXUQV'RQRWGLVDVVHPEOHKHDWDERYH&)RU
LQFLQHUDWH'RQRWH[SRVHFHOOVRUEDWWHULHVWRKHDWRUILUH$YRLGVWRUDJHLQGLUHFWVXQOLJKW
2. 'LVSRVHRIXVHGEDWWHU\SURPSWO\:KHQGLVSRVLQJRIVHFRQGDU\FHOOVRUEDWWHULHV
keeSFHOOVRUEDWWHULHVRIGLIIHUHQWHOHFWURFKHPLFDOV\VWHPV VHSDUDWHIURPHDFKRWKHU
3. .HHSEDWWHU\RXWRIUHDFKRIFKLOGUHQDQGLQRULJLQDOSDFNDJHXQWLOUHDG\WRXVH
4. 1HYHUSXWEDWWHULHVLQPRXWK,IVZDOORZHGFRQWDFW\RXUSK\VLFLDQ
RUORFDOSRLVRQFRQWUROFHQWHU
5. &$87,21²7KHEDWWHU\XVHGLQWKLVGHYLFHPD\SUHVHQWDULVNRIILUHRUFKHPLFDOEXUQLI
PLVWUHDWHG5HSODFHEDWWHU\ZLWKPDQXIDFWXUHURQO\8VHRIDQRWKHUEDWWHU\PD\SUHVHQW
DULVNRIILUHRUH[SORVLRQ
6. :DUQLQJ'RQRWXVHDYLVLEO\GDPDJHGEDWWHU\SDFNRUWRRODVDSSOLFDEOH
7. :DUQLQJ'RQRWPRGLI\RUDWWHPSWWRUHSDLUWKHWRRORUWKHEDWWHU\SDFN
DVDSSOLFDEOH
8. %$77(5<0867%(5(&<&/('