E24WC50QS

Electrolux E24WC50QS, E24WC50QS , E24WL50QS Product information

  • Hello! I am an AI chatbot trained to assist you with the Electrolux E24WC50QS Product information. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
SERVICE DATA SHEET
41013619
WINE COOLER - R134a
IMPORTANT SAFETY NOTE
The information provided herein is designed to assist
qualified repair personnel only. Untrained persons should not
attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
IMPORTANT
If any green grounding wires are removed during servicing,
they must be returned to their original position and properly
secured.
CAUTION
All electrical parts and wiring must be shielded from torch
ame. DO NOT allow torch to touch insulation; it will char
at 200°F and ash ignite (burn) at 500°F. Excessive heat
will distort the plastic liner.
IMPORTANT: PLEASE RETURN THIS SHEET
TO IT'S ORIGINAL LOCATION.
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS
AT MID-POINT CONTROL SETTINGS
Type A with Run/Start
Capacitor
65° (18°C) Ambient 90° (32°C) Ambient
Operating Time 8 to 15% 20 to 40%
Temperature 40°F to 65°F 40°F to 65°F
Low Side Pressure (cut-in)
25 to 50 psig
172 to 345 kPa
25 to 50 psig
172 to 345 kPa
Low Side Pressure (cut-out)
0 to 10 psig
0 to 69 kPa
0 to 10 psig
0 to 69 kPa
High Side Pressure
(last 1/3 cycle)
95 to 125 psig
655 to 862 kPa
130 to 175 psig
896 to 1207 kPa
Wattage (last 1/3 cycle) 55 to 80 55 to 80
Amps (running) .45 to .85 .45 to .85
Base voltage 115 vac (127 vac max)
CONDENSER FAN MOTOR
Watts RPM Amps
4.1 1280 0.06
EVAPORATOR FAN MOTOR
1.08 2550 0.09
NOTE
Your Electrolux wine cooler has been designed for either
free-standing or built-in installation. When built-in, your
wine cooler does not require additional air space for top,
sides or rear. In either case, the front grille must NOT be
obstructed.
To ease unit installation and removal, it is recommended
that the cabinet rough opening dimensions be increased by
at least ¼ inch over the dimensions given for the unit.
All units require zero clearance when installed flush with a
cabinet or wall. Electrolux stainless steel models require a
minimum 2
15
32 inch handle clearance when installed
against a wall or cabinet that extends beyond the front
edge of the unit.
Unit Dimensions
Width Height Depth
23
7
8 inch 33
3
4 to 34
3
4 inch 26
11
32 inch
To p
View
Side
View
Front
View
3
11
32"
23
7
8"
26
11
32"
23
23
32"
21½"
33
3
4"
Adjustable to
34
3
4"
2
15
32"
46
13
32"
2
11
16"
BLACK (SMOOTH)
BLACK (RIBBED)
SERVICE
CORD
CONDENSER
FAN
FAN LOW
CABINET
TEMP SENSOR LOW
EVAPORATOR
DEFROST SENSOR
GREEN
GROUND
RED
BLUE
RED
WHITE
WHITE
RED
RED RED
BLACK BLACK
COMM.
WHITE
WHITE
WHITE
WHITE
RUN
CAPACITOR
DOOR
SENSOR
BLACK
BLACK
BLUE
WHITE
SWITCH
LOW
SWITCH
UP
WHITE WHITE
SWITCHES
(RD ONLY)
B
WHITE
WHITE WHITE
BLU
BLU
BLU
RED
RED
RED
TIP SPRING
RING SPRING
LIGHTS
USER
INTERFACE
COMPRESSOR
PROGRAMMING/
DATA ACQUISITION PORT
(MODELS WITH RS485 BOARDS ONLY)
BLUE WIRE PIN 2
WHITE WIRE PIN 3
/