Kompernass Impact Driver KH 4055 User manual

Type
User manual

This manual is also suitable for

  WHEEL NUT WRENCH KH4055
Powerfix
IB_KH4055_0706_UK.qxd 18.09.2006 14:11 Uhr Seite 1
2
Intended use
The wheel nut wrench KH4055 is intended for
loosening and tightening of wheel nuts / bolts
during a tyre change.
Technical data
Length: 350 mm - 530 mm
Wrench widths: 17 mm and 19 mm
Using the wheel nut wrench
• Park the vehicle on a level surface, put it in
a low gear and set the hand break.
• Also secure the vehicle against rolling with
appropriate equipment.
Important:
Follow the safety / operating instructions in the
operating manual for your vehicle.
• Loosen the wheel nuts / bolts of the wheel to
be changed in an alternating cross pattern before
lifting the vehicle with the jack.
IB_KH4055_0706_UK.qxd 18.09.2006 14:11 Uhr Seite 2
3
• Lift the vehicle until the wheel to be changed is
no longer in contact with the floor.
• Remove the wheel nuts / bolts in an alternating
cross pattern and remove the wheel.
• Put the replacement wheel in position and tightly
screw in the wheel nuts / bolts.
• Lower the vehicle and retighten the wheel nuts
in an alternating cross pattern with the wheel
nut wrench.
Important:
After changing the wheel, check the air pressure
in all tyres.
The wheel nuts / bolts must be inspected again
and retightened after approximately 50 km.
Do not perform any work under the vehicle while
it is lifted up with the jack.
IB_KH4055_0706_UK.qxd 18.09.2006 14:11 Uhr Seite 3
Kompernaß GmbH
Burgstrasse 21
D-44867 Bochum
www.kompernass.com
ID No.: KH4055_0706_V1
UK
IB_KH4055_0706_UK.qxd 18.09.2006 14:11 Uhr Seite 4
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Kompernass Impact Driver KH 4055 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI