BOYUXON Q1 Magnetic Wireless Car Charger User manual

Brand: BOYUXON

Model: Q1 Magnetic Wireless Car Charger

Type: User manual

4.Insert the clip into the air outlet,

release the shrapnel and adjust

the support foot.

1. Install the nut and set the ball

intothe nut.

Product Name

Output

Frequency

Working Temperature

Charging Distance

Material

USB-CPort Type

3.Press the shrapnel to open the

clip.

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator & your body.

FCC Warning

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

Brand BOYUXON

2. Insert the spinning ball into the

screw post behind the wireless

charger.

Then rotate the fixed nut

to the proper tightness.

Customer Service: [email protected]

Magnetic Wireless Car Charger

Customer Service: [email protected]

Model

Net Weight

Application

Mounting Type

Input

the type-c port on the car.

into the QC power adapter or

85g

4.5-7.0 inches phone

Vent

5-12V 2A (Max)

15W(Max)

115 ~ 205kHz

2-5mm

85%

ABS+Nano lens

5.Plug the type-c charging cable

magnetic wireless car charger.

area,start charging with BOYUXON

6.Place your phone on the charging

receiver separately to activate the wireless charging function.

Qi-compatible

.For some device without Qi, you may need to buy a 5

included.

isrequired for the fast wireless charging.Power adapter is not

4.A Quick Charge 3.0 or Quick Charge 2.0 enabled power adapter

phone properly in the wireless charging area.

phone case and other metal or magnetic objet, and place your

.To get the optimal performance, please remove your protective

with magnetic function on the back.

1.BOYUXON magnetic wireless charger only suitable for phones

Note:

.BOYUXON magnetic wireless charger only supports USB-C

output port.

Conversion

Efficiency

Magnetic wireless car charger

-10°C ~ 60°C

Magnetic Wireless Car Charger

BOYUXON Q1 Magnetic Wireless Car Charger User manual

Brand: BOYUXON

Model: Q1 Magnetic Wireless Car Charger

Type: User manual

Download PDF

report