www.cls-led.com www.cls-led.com
3 4
TECHNICAL
Specifications
LED: 1 x High Power LED
Available colours: CRI>90: 2500K, 2700K, 3000K & 4000K
CRI>95: 2700K, 3000K, 3500K & 4000K
Beam angle: 15º, 30º or 50º
Power supply: Max. 1050mA
Power consumption: max. 37 Watt or max. 55 Watt
Housing: PC / aluminium
Weight: 1300 gr
IP value: IP20
Ambient temperature: -10º C till +40º C
Tools
ø 220 mm
PH1
2022 CLS-LED BV. All rights reserved. Information
subject to change without notice, CLS-LED BV and
all aliated companies disclaim liability for injury,
damage direct or indirect loss, consequential or
economic loss or any other loss occasioned by the
use of, inability to use or reliance on the information
contained in this manual. No part of this manual
may be reproduced, in any form or by any means,
without permission in writing from CLS-LED BV.
Other legal information can be found in our General
conditions, found on the back of your CLS-LED BV
invoice, inside the CLS catalogue or on our website
www.cls-led.com/General-Terms.pdf
ø 260 mm
153 mm
3 mm
Cutout size
ø 210 - 250 mm
INSTALLATION
Otis GII: ø 210 - max. 250 mm
Minimal Built-in
height 20 cm
To driver
2
1
Suspended
ceiling
Otis GII: ø 210 - max. 250 mm
Minimal Built-in
height 20 cm
To driver
2
34
Before use, read this carefully
> Always disconnect the power before connecting the
LED xtures otherwise this will cause serious damage!
> Make sure the unused outputs has been shorted with
a shortcut connector before connecting the power.
> Before use please check the correct dipswitch setting.
(See sticker on the driver)
> The driver must be set to 1050mA. Shortcut connector
LED xture