Ritron RQX-127-XT-KP, New-"Enforcer" Keypad Programming Manual, New-"Enforcer" Keypad Wiring Instructions, RQX-427-XT-KP Wiring Instructions

Hello! I have reviewed the Wiring Instructions for the Ritron Keypad RQX-XT-KP. This document provides essential guidance on how to properly wire the DTMF keypad, including faceplate removal and correct wiring connections. I'm ready to assist you with any specific questions you might have about this process.
What tool is needed to remove the Callbox faceplate?

Where should the keypad wire assembly be connected?

Should I connect the keypad wire assembly to the RQX-XT cable assembly?

INSTRUCTIONS

Pub. No. 14500072B 08/23/23

RQX-XT-KP WIRING INSTRUCTIONS

1. To wire the DTMF Keypad to the controlling device, the Callbox metal faceplate must be removed.

Use the T-25 Security Torx-Head driver (included with the Callbox), remove the (4) large Torx screws

securing the faceplate to the Callbox case.

2. Refer to the Enforcer Outdoor Stand-Alone Weatherproof Keypads Manual (included with the Ritron RQX-

XT-KP Callbox) to connect the DTMF Keypad to the controlling device.

IMPORTANT! – DO NOT connect the keypad wire assembly (Fig.-1) to the RQX-XT 6-conductor cable

assembly (Fig.-2). The keypad wire assembly should be wired directly to the controlling device.

Refer to the Enforcer Outdoor Stand-Alone Weatherproof Keypads Manual that is included in this

package for wiring connections and instructions.

Fig.-1 – Keypad Wire Assembly Fig.-2 – RQX-XT Cable Assembly

505 W. Carmel Dr. · Carmel, Indiana 46032 · PH: 317.846.1201 · Email: ritron@ritron.com · www.ritron.com

Remove

Keypad

Wire

Assem

bly

RQX-XT

Cable

Assembly