Ritron New-"Enforcer" Keypad Programming Manual Wiring Instructions

INSTRUCTIONS

Pub. No. 14500072B 08/23/23

RQX-XT-KP WIRING INSTRUCTIONS

1. To wire the DTMF Keypad to the controlling device, the Callbox metal faceplate must be removed.

Use the T-25 Security Torx-Head driver (included with the Callbox), remove the (4) large Torx screws

securing the faceplate to the Callbox case.

2. Refer to the Enforcer Outdoor Stand-Alone Weatherproof Keypads Manual (included with the Ritron RQX-

XT-KP Callbox) to connect the DTMF Keypad to the controlling device.

IMPORTANT! – DO NOT connect the keypad wire assembly (Fig.-1) to the RQX-XT 6-conductor cable

assembly (Fig.-2). The keypad wire assembly should be wired directly to the controlling device.

Refer to the Enforcer Outdoor Stand-Alone Weatherproof Keypads Manual that is included in this

package for wiring connections and instructions.

Fig.-1 – Keypad Wire Assembly Fig.-2 – RQX-XT Cable Assembly

505 W. Carmel Dr. · Carmel, Indiana 46032 · PH: 317.846.1201 · Email: ritron@ritron.com · www.ritron.com

Remove

Keypad

Wire

Assem

bly

RQX-XT

Cable

Assembly

This manual is also suitable for

Download PDF