Event Lighting VIVIDSTARTER LED Party Bar Light User manual

Event Lighting
Brand
Event Lighting
Model
VIVIDSTARTER LED Party Bar Light
Type
User manual

Event Lighting VIVIDSTARTER LED Party Bar Light

This device is a versatile lighting solution for parties and events. It features a combination of PAR lights, LED balls, a strobe, and lasers, providing a wide range of lighting effects to enhance any celebration.

With its auto, sound-activated, and IR remote control modes, you can effortlessly set the lighting to match the atmosphere of your event. The 7x 2W RGB LED PAR lights, 3x 3W RGB LED balls, and 3x 4W UV/white LED strobe offer a spectrum of colors and patterns to create a dynamic and immersive light show.

Furthermore, the device comes with a stand for easy setup and includes a red laser (100mW) and green laser (30mW) to add an extra touch of excitement and visual impact.

Event Lighting VIVIDSTARTER LED Party Bar Light

This device is a versatile lighting solution for parties and events. It features a combination of PAR lights, LED balls, a strobe, and lasers, providing a wide range of lighting effects to enhance any celebration.

With its auto, sound-activated, and IR remote control modes, you can effortlessly set the lighting to match the atmosphere of your event. The 7x 2W RGB LED PAR lights, 3x 3W RGB LED balls, and 3x 4W UV/white LED strobe offer a spectrum of colors and patterns to create a dynamic and immersive light show.

Furthermore, the device comes with a stand for easy setup and includes a red laser (100mW) and green laser (30mW) to add an extra touch of excitement and visual impact.

VIVIDSTARTER
LED Party Bar Light with PAR, LED Balls, Strobe and Laser
USER MANUAL
For safety, please read this user manual carefully before initial use.
Event Lighting reserves the right to revise the manual at any time. Information and specifications
within this manual are subject to change without notice. Event Lighting assumes no liability or
responsibility for any errors or omissions. Please consult Event Lighting for any clarification or
information regarding this item.
Version: 1
www.event-lighting.com.au
2
Safety Instructions
Warning
• Do not open this fixture, there is no user-serviceable parts inside. Risk of electric shock.
• Do not look directly at the light source when the fixture is on.
Caution: This unit’s housing may become hot during and after operation.
• Install this fixture in a location with adequate ventilation, at least 50 cm from adjacent
surfaces.
• Do not leave any flammable material within 50 cm of this unit while operating or
connected to power.
• Use a safety chain when mounting this fixture overhead.
• Do not operate this device in any location where excessive dust, heat, water or humidity
may affect it.
• Do not operate this fixture if the housing, lenses, or cables appear damaged.
• Do not connect this fixture to a dimmer or rheostat.
• ONLY connect this fixture to a grounded and protected circuit.
• ONLY use the hanging bracket to carry this fixture.
• In case of a serious operating problem, stop using immediately.
• The maximum ambient temperature is 40° C. Do not operate this fixture at higher
temperatures.
Power Input
This fixture has an auto switching power supply that works with an input voltage range of 110-
240V AC, 50/60 Hz.
IR Remote
www.event-lighting.com.au
3
Technical Specifications
• PAR: 7x 2W RGB LED
• LED Ball: 3x 3W RGB LED
• Strobe: 3x 4W UV/Whtie LED
• Red Laser: 100mW
• Green Laser: 30mW
• Operation Modes: Auto, sound active, IR remote (included)
• Stand included
• Input Voltage: 110-240V AC, 50/60 Hz
• Power Consumption: 40 W
Warranty
Please contact your local dealer or contact Event Lighting.
www.event-lighting.com.au
  • Page 1 1
  • Page 2 2
  • Page 3 3

Event Lighting VIVIDSTARTER LED Party Bar Light User manual

Event Lighting
Brand
Event Lighting
Model
VIVIDSTARTER LED Party Bar Light
Type
User manual

Event Lighting VIVIDSTARTER LED Party Bar Light

This device is a versatile lighting solution for parties and events. It features a combination of PAR lights, LED balls, a strobe, and lasers, providing a wide range of lighting effects to enhance any celebration.

With its auto, sound-activated, and IR remote control modes, you can effortlessly set the lighting to match the atmosphere of your event. The 7x 2W RGB LED PAR lights, 3x 3W RGB LED balls, and 3x 4W UV/white LED strobe offer a spectrum of colors and patterns to create a dynamic and immersive light show.

Furthermore, the device comes with a stand for easy setup and includes a red laser (100mW) and green laser (30mW) to add an extra touch of excitement and visual impact.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI