ETERNUS CS800 SCALE QUICK START

Using variable-length deduplication, CS800 SCALE provides scalable, backup storage. CS800 SCALE provides easy to

configure disaster recovery protection when it is paired with one or more systems as a replication target.

The ETERNUS CS800 SCALE is an OEM product and functionally identical to Quantum DXi4800. All links below point to

Quantum documentation, which can be used for CS800 SCALE as well. For complete documentation, including pre-

installation requirements, see the DXi4800 Documentation Center: www.quantum.com/DXi4800docs.

For installation and service contact Fujitsu support: https://support.ts.fujitsu.com

Your system includes a Node, or a Node and up to four Expansion Modules (EMs).

Installing ETERNUS CS800 SCALE

Important

Install the Node and EMs in the rack and connect all cables before following the power-up sequence.

Step 3 Install any Expansion Modules; then

install the Node above the Expansion

Modules. See Install > DXi4800 System

Installation > Install the DXi4800 System

in the Rack.

Step 4 Cable the DXi4800. See Install >

DXi4800 System Installation > Install the

DXi4800 System in the Rack > Cable the

Node (top)

EM (bottom)

Back

Optional

Fibre Channel

Configuring ETERNUS CS800 SCALE

At a minimum, you must complete the following steps to get your system up and running.

See Install > DXi4800 System Installation > Perform Initial Configuration.

You can configure and schedule replication as needed.

See Operate > DXi4800 User Guide > DXi4800

Replication.

Operating the ETERNUS CS800 SCALE

Step 4 Connect the Ethernet cables. For a video, click the

Step 5 Install the front bezel.