2. Transmitter
  3. iGAZEREKIT-UL
iGAZEREKIT-UL

Transmitter iGAZEREKIT-UL Product information

  • Hello! I'm a chat assistant that has reviewed the user manual for the Maximum Controls 66HD, 50LR Photo Eyes and RE KIT Receiver. I'm familiar with the device learning procedures, wiring guidelines, and monitoring requirements detailed within this document. I'm ready to answer your questions about these products and their integration with the Matrix III system.
  • What type of power source should be used for the TX on Primary/Secondary installs?
    What is the key requirement for N.C. type sensing devices?
    How do I learn devices using the Matrix system?
    What should I do if input LED’s flash after programming?
UL SENSOR 10k UL SENSOR N.C.
OPEN ONLY 10K
CLS ONLY 10K
OPEN/CLS 10K
12VDC OUT
GND
OPEN ONLY NC
PHOTO CLS NC
OPEN/CLS NC
12VDC OUT
GND
IMPORTANT: N.C. type sensing
devices MUST be powered by
Matrix III 12VDC OUT input or
they will NOT be MONITORED.
TX
12/24 V
66HD Photo Eye
Factory Learned Input
Factory Learned Input
12VDC OUT monitored
Additional Unlearned Input
Additional Unlearned
Input
Unlearned Input
Unlearned Input
66HD Photo Eye
50LR Photo Eye
TP2
RX
TP1
COM
NO
NC
12 - 30V DC/AC 60 Hz
Non Polarity
TestC
Test2
Test1
NC2
C2
NC1
To Operator To Operator
12/24
Vac/dc
C1
1 2 3 4 5 6 7
NO2
NO1
RE KIT RECEIVER
On Primary / Secondary installs the TX
must be powered from a non moni-
tored source i.e. any power output on
the Matrix lll other than the 12VDC
supply on the “UL Sensor NC” connec-
tor.
To learn devices press and
hold stop and open until the
beeping begins, release,
confirm that your input
LED’s are solid blue, then
press stop. If input LED’s
flash after programming,
communication has not
been established. Check
your wires and device.
/