Kohler K-302-K-NA Installation guide

Installation and Care Guide

Two-Valve and Three-Valve Wall-Mount

Bath/Shower Fitting

M product numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

M corresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-302 K-303

K-6934

1205552-2-A

Tools and Materials

Before You Begin

Please read all instructions before you begin.

Observe all local plumbing and building codes.

Shut off the main water supply.

Do not remove the plaster guards until instructed to.

Before installation, unpack the components and inspect them for

damage. Return the components to the carton until you are ready

to install.

1205552-2-A 2 Kohler Co.

Rough-In

8" (293 mm) Typical

4" (102 mm) (Bath Only)

48" (1219 mm)

To Floor

(Shower Only)

48" (1219 mm)

To Floor

(Shower Only)

6' (1829 mm)

To Floor Typical

2-1/4" (57 mm) Min

3" (76 mm) Max

4" (102 mm)

2-1/4"

(57 mm)

1/2" NPT or

1/2" Copper

4" (102 mm) Typical

8" (293 mm) Typical

4" (102 mm) (Bath Only)

2-1/4"

(57 mm)

4" (102 mm)

6' (1829 mm)

To Floor Typical

2-1/4" (57 mm) Min

3" (76 mm) Max

1/2" NPT or

1/2" Copper

1/2" NPT Hot

1/2" NPT Tap

Top of Rim

1/2" NPT Hot

1/2" NPT Tap

Top of Rim

1/2" NPT

Cold

1/2" NPT

Cold

1/2" NPT Tap

Kohler Co. 3 1205552-2-A

1. Bath and Shower Installation

NOTE: Typical dimensions for bath and shower installations are

shown on the rough-in diagram.

NOTE: Refer to the trim installations instructions for speciﬁc

requirements.

NOTE: Refer to the handle installation instructions for possible

rough-in depth requirements.

NOTE: The faucet ﬁtting is factory assembled for hot and cold

water.

Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57

mm) minimum to 3″ (76 mm) maximum from the centerline of

the yoke to the outside of the ﬁnished wall.

Install 1/2″ hot and cold supply tubing.

If speciﬁed, install the screwdriver stop valves.

NOTE: The three-valve yokes have no embossed graphics for the

showerhead and spout locations.

Elbow

Adapters

1/2" Copper

Tubing

Temporary

Nipple

Temporary

Nipple

1/2" Copper

Tubing

Yoke

Stop

Valve

1/2"

Piping

1/2"

Piping

1/2" Copper

Tubing

1/2"

Threaded

Pipe

Union

1/2"

Sweat

Copper

Union

1205552-2-A 4 Kohler Co.

2. Complete the Bath and Shower Installation

For Ceiling Installations

NOTE: Do not use a three-valve yoke with ceiling supplies.

Turn the yoke over to allow the supplies to connect from the top

of the yoke.

Remove the aspirator with a 3/8″ hex wrench and reinstall it in

the top of the yoke. Do not overtighten.

NOTE: Reversing the yoke for ceiling supplies will reverse the

direction in which the lever handles close.

For proper lever handle operation, open the valves and remove

and reverse the ceramic valves.

Make sure the valves are not dirty or damaged.

Wrench tighten the valves.

For All Installations

Install copper tubing and adapters between the yoke and shower

ell.

Install copper tubing and adapters between the yoke and bath ell.

Secure the tubing to the framing.

Install temporary 1/2″ nipples into the shower and bath ells.

Ceiling

Supplies

Cold

Aspirator

Hot

Thread

Protector

Valve Unit

Shower

Ell

Bath

Ell

Adapters

for

Copper

Tubing

1/2"

Copper

Tubing

Temporary

Nipple

Temporary

Nipple

Kohler Co. 5 1205552-2-A

3. Shower Only Installations

NOTE: Shower only installations require two-valve yokes.

NOTE: Typical dimensions for bath and shower installations are

shown on the rough-in diagram.

NOTE: Refer to the trim installation instructions for speciﬁc

requirements.

NOTE: Refer to the handle installation instructions for possible

rough-in depth requirements.

Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57

mm) minimum to 3″ (76 mm) maximum from the centerline of

the yoke to the outside of the ﬁnished wall.

Install 1/2″ hot and cold supply tubing.

If speciﬁed, install the screwdriver stop valves.

Using a 3/8″ hex wrench, remove the aspirator from the yoke and

discard.

Install a plug in the spout pipe opening.

Plug

24"

(610 mm)

72"

(1829 mm)

To Floor

1205552-2-A 6 Kohler Co.

4. Bath Only Installations

NOTE: Bath only installations require two-valve yokes.

NOTE: Typical dimensions for bath and shower installations are

shown on the rough-in diagram.

NOTE: Refer to the trim installation instructions for speciﬁc

requirements.

Unless otherwise instructed, rough-in the supply yoke 2-1/4″ (57

mm) minimum to 3″ (76 mm) maximum from the centerline of

the yoke to the outside of the ﬁnished wall.

Install 1/2″ hot and cold supply tubing.

If speciﬁed, install the screwdriver stop valves.

NOTE: Three-valve yokes have no embossed graphics for the

showerhead and spout locations.

Using a 3/8″ hex wrench, remove the aspirator from the yoke and

discard.

Install a plug in the showerhead pipe opening.

Warranty

KOHLER

®

Faucet Lifetime Limited Warranty

Kohler Co. warrants its Faucets* manufactured after January 1, 1997, to

be leak and drip free during normal residential use for as long as the

original consumer purchaser owns his or her home. If the Faucet

Plug

Temporary

Nipple

4"

(102 mm)

Kohler Co. 7 1205552-2-A

Warranty (cont.)

should leak or drip during normal use, Kohler Co. will, free of charge,

mail to the purchaser the cartridge necessary to put the Faucet in good

working condition. This warranty applies only to Kohler Faucets

installed in the United States of America, Canada or Mexico (″North

America″).

Kohler Co. also warrants all other aspects of the faucet or accessories

(″Faucet″)*, (except gold, non-Vibrant

®

, non-chrome ﬁnishes) to be free

of defects in material and workmanship during normal residential use

for as long as the original consumer purchaser owns his or her home.

This warranty applies only to Kohler Faucets installed in North

America. If a defect is found in normal residential use, Kohler Co. will,

at its election, repair, provide a replacement part or product, or make

appropriate adjustment. Damage to a product caused by accident,

misuse, or abuse is not covered by this warranty. Improper care and

cleaning will void the warranty**. Proof of purchase (original sales

receipt) must be provided to Kohler Co. with all warranty claims.

Kohler Co. is not responsible for labor charges, installation, or other

incidental or consequential costs. In no event shall the liability of

Kohler Co. exceed the purchase price of the Faucet.

If the Faucet is used commercially or is installed outside of North

America, or if the ﬁnish is gold, non-Vibrant or a painted or powder

coated color ﬁnish, Kohler Co. warrants the Faucet to be free from

defects in material and workmanship for one (1) year from the date the

product is installed, under Kohler Co.’s standard one-year limited

warranty.

If you believe that you have a warranty claim, contact Kohler Co.,

either through your Dealer, Plumbing Contractor, Home Center or

E-tailer, or by writing Kohler Co., Attn.: Customer Care Center, 444

Highland Drive, Kohler, WI 53044, USA. Please be sure to provide all

pertinent information regarding your claim, including a complete

description of the problem, the product, model number, color, ﬁnish,

the date the product was purchased and from whom the product was

purchased. Also include your original invoice. For other information,

or to obtain the name and address of the service and repair facility

nearest you, call 1-800-4-KOHLER (1-800-456-4537) from within the

USA and Canada, and 001-800-456-4537 from within Mexico, or visit

www.kohler.com within the USA, www.ca.kohler.com from within

Canada, or www.mx.kohler.com in Mexico.

KOHLER CO. AND/OR SELLER ARE PROVIDING THESE

WARRANTIES IN LIEU OF ALL OTHER WARRANTIES,

EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO

THE IMPLIED WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE. KOHLER CO. AND/OR

1205552-2-A 8 Kohler Co.

Warranty (cont.)

SELLER DISCLAIM ALL LIABILITY FOR SPECIAL, INCIDENTAL

OR CONSEQUENTIAL DAMAGES. Some states/provinces do not

allow limitations of how long an implied warranty lasts or the

exclusion or limitation of such damages, so these limitations and

exclusions may not apply to you. This warranty gives the consumer

speciﬁc legal rights. You may also have other rights that vary from

state/province to state/province.

This is Kohler Co.’s exclusive written warranty.

*Trend

®

faucets, MasterShower

®

tower, BodySpa systems and

components; WaterHaven

®

tower, systems and components; Tripoint

®

faucets, Polished Gold, non-Vibrant and painted or powder coated

ﬁnishes, ﬁttings; all items within the ″Fixture Related″ section of the

Kohler Faucets Price Book, drains, Duostrainer

®

sink strainers,

soap/lotion dispensers, Moxie

TM Wireless Speaker; and faucets used in

commercial settings, and outside North America, are covered by

Kohler Co.’s one-year limited warranty.

**Never use cleaners containing abrasive cleansers, ammonia, bleach,

acids, waxes, alcohol, solvents or other products not recommended for

chrome. This will void the warranty.

Kohler Co. 9 1205552-2-A

Page is loading ...

Kohler K-302-K-NA Installation guide

This manual is also suitable for

Kohler K-302-K-NA Installation guide

in other languages

Related papers

Other documents