ABS MegaCam HS421X 6” Outdoor Housing
(for 421M/4210 Network Camera)
Easy Installation Guide
www.abs.com
Easy Installation Guide for ABS MegaCam HS421X 6” Outdoor Housing (for 421M/4210 Network Camera)
©1990-2008 ABS Computer Technologies Inc. All Rights Reserved 2
ABS MegaCam HS421X 6” Outdoor Housing
(for 421M/4210 Network Camera)
Thank you for purchasing the ABS MegaCam HS421X outdoor housing/enclosure for MegaCam
421M/4210 Network Cameras. With the correct installation, the 421M/4210 camera can be used for
outdoor environment under IP66 protection. Please follow the steps below for installation:
Step 1:
Open outer carton, there are 2 boxes inside:
Step 2:
Take out all the components.
Wall mount Outdoor housing
Wall Mount
12V
Adapto
r
*Cross bridge
Power cable
Screws Outdoor
housing
Easy Installation Guide for ABS MegaCam HS421X 6” Outdoor Housing (for 421M/4210 Network Camera)
©1990-2008 ABS Computer Technologies Inc. All Rights Reserved 3
Step 3:
Feed power adaptor and LAN cable through wall mount bracket.
Step 4:
Insert the cables into outdoor housing. The cables should go through the center of the electrical
board.
Step 5:
Fasten the wall mount onto the outdoor housing. Use L-wrench to screw the outdoor housing
tightly.
Step 6:
Use the small screws to secure the outdoor mounting bracket to the bottom side of the IP Network
Camera.
Easy Installation Guide for ABS MegaCam HS421X 6” Outdoor Housing (for 421M/4210 Network Camera)
©1990-2008 ABS Computer Technologies Inc. All Rights Reserved 4
Step 7:
Move the LAN cable underneath and to the side of the electrical board. Insert the 12V DC power
adaptor to electrical board connector marked “DC In”.
Note: Minimum requirement is 12V DC 1.5A adaptor (DC for both P/T IP cam and heater/fan)
Step 8:
Insert “power transmission cable” to the electric board connector marked “DC Out”.
Move LAN cable from center to side Insert power adaptor to “DC in” connector
Power transmission
cable
Insert to “DC
Out” connector
Put cables in order
Easy Installation Guide for ABS MegaCam HS421X 6” Outdoor Housing (for 421M/4210 Network Camera)
©1990-2008 ABS Computer Technologies Inc. All Rights Reserved 5
Step 9:
Using the long screws and standoffs, fix the bridge (with P/T IP cam) onto the outdoor housing
Step 10:
Insert the power cable and LAN cable to the P/T IP cam connectors. Fasten the transparent cover to
the outdoor housing.
Congratulations! You have completed the installation of the outdoor housing.
/
