PULL ASSY
MOUNTING
SCREW
Step 1:
Determine your desired location for installation and make a mark for the location.Make mark where mounting screw will be
placed as shown below. Drill hole at the mark.
Drill holes for the desired location.
Pull Mounting
Step 2:
Place Pull to the desired location and screw from behind.
SURFACE MOUNTED
101
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI