Vita-Mix Inc. The Quiet One Installation guide

Brand
Vita-Mix Inc.
Model
The Quiet One
Type
Installation guide
DRIVE SOCKET REPLACEMENT INSTRUCTIONS
Caution: To avoid broken drive socket, use the tamper only with the lid in place.
1.
Unplug unit from power supply and remove container from base.
2.
Turn base so back of machine is facing you, except for the Blending Station,
®
which should
face front.
3.
Remove rubber centering pad from base.
4.
Locate arrow on top of black drive socket (arrow is raised and can be felt by touch). Rotate drive
socket until the arrow (set-screw) is aligned with slot in housing. (See Figure A)
5.
Note angle of setscrew (See Figure B). Insert 5/64” hex wrench – it may be necessary to push
wrench through silicone sealant in housing slot. Turn hex wrench counter-clockwise, 4-5
complete turns, loosening setscrew.
6.
If the drive socket cannot be easily pulled off due to melted
plastic or burrs on the motor shaft (from the machine being
run even briefly with the broken drive socket), (See Figure C)
follow steps A, B, and C.
A.
Replace rubber centering pad and pry the drive socket off
with two sturdy tools (such as screw drivers) by applying
equal pressure to both pry tools.
B.
Once drive socket is off, remove rubber centering
pad again.
C.
Remove any debris from around the motor shaft.
7
. Locate raised arrow on top of the new drive socket, align
squared bottom of drive socket with squared top of motor shaft.
8
. Push drive socket straight down then rotate until the arrow
(setscrew) is aligned with slot in housing. (See Figure A)
9
. Angle hex wrench and tighten clockwise until you feel the
screw hit the shaft or it stops going in. Then Back off 1/4 turn. Do not overtighten as stripping
out the screw head, hole or threads could occur. See NOTE.*
10.
Replace rubber centering pad, making sure to push the rubber down all the way around the
center to avoid the centering pad and the drive socket from rubbing together.
11.
Reconnect base to power supply.
*NOTE: Test unit with container in place. Turn machine on briefly with hand rested on lid. If the container
vibrates excessively, remove drive socket, and rotate it 1/4 turn before reinstallation. If necessary try all 4
(1/4) turns to find the best balance. Follow steps 7-11 to finish drive socket replacement. Drive sockets are
usually only broken by the presence of something foreign in the container, such as a lid plug, spoon, etc.
Please avoid making this mistake by keeping all foreign objects out of the container.
Drive socket
Setscrew
Figure A (Rear View)
Figure B (Cut Away Side View)
Figure C
Setscrew
XDM006 6/03
© 2003 Vita-Mix Corporation
Hex Wrench
Housing
Rear Front
  • Page 1 1

Vita-Mix Inc. The Quiet One Installation guide

Brand
Vita-Mix Inc.
Model
The Quiet One
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents