Refer to Product Safety Manual for Safety Statements
Complete Owner’s Manual available online
Quick Start Reference Guide
The switching operation of this microwave oven can cause voltage uctuations on the supply line. The operation of this oven under unfavorable voltage
supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximum permissible system
impedance Zmax of 0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connected only to a power
supply system which fullls the requirement above. If necessary, the user can ask the public power supply company for the system impedance at
the interface point.
Oven Wall Clearances
A—For North American (UL/CSA) models,
allow at least 3” (7.2 cm) of clearance
around top of oven. For International (50
Hz) models, allow at least 12” (30 cm) of
clearance around top of oven. Proper air ow
around oven cools electrical components.
With restricted air ow, oven may not
operate properly and life of electrical parts is
reduced.
B—Allow at least 3” (7.2 cm) between air
discharge on back of oven and back wall.
C—Allow at least 3” (7.2 cm) of clearance
around side of oven. One side of oven must
be open.
No metal pans
DO NOT power spray
2010 ACP , Inc.
Cedar Rapids, Iowa 52404
Part No.20037401
Revised 7/10
For full product documentation visit:
www.acpsolutions.com
So...how do I use it? (Mechanical Dial)
Heating
1. Open oven door, place food in oven, and close oven door.
2. Turn time entry knob clockwise to desired time.
• Cooking time can be set up to 6 minutes.
• Oven begins operation and time counts down.
3. When cooking time has elapsed, microwave energy stops and oven
signal sounds.
Interrupting Operation
Open oven door to interrupt operation or turn time entry knob
counterclockwise to “0”.
To resume microwave oven operation, close door and turn knob.
Changing Time and Canceling Mistakes
Heating time can be changed at any time while the oven is operating.
Turn knob to desired new setting. To set cooking time to zero, turn knob
counterclockwise to “0”.
Menu Guide
2:00
1:00-2:00
1:30-2:30
15
45
:30
:
:
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Menumaster Microwave Oven Owner's manual
-
ACP RCS10A User manual
-
-
-
-
Maytag P1327811M Owner's manual
-
Maytag UALD510 Operating instructions
-
Metos DEC18E2 230/1N/50 Owner's manual
-
-
