Installation instructions
Steam cooker
Construction type 60-381
J56A.113-0
26.11.11 WIMA
1
These installation instructions apply to the model: 56A
Identification plate
➤ Open the appliance door. The identification plate is located on the left trim panel
(see illustration).
➤ Refer to the identification plate for specifications for the required mains voltage, current type and fuses.
➤ Application height of the appliance: up to max. 2000 m above sea level
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be
strictly observed.
To ensure good ventilation, the niche in which the appliance stands must have a supply air opening of at least 25 cm
2
.
This appliance is considered to be suitable for use in countries having a warm damp equable climate (WDaE). It may also be
used in other countries. If used in warm damp equable climated countries, the appliance is to be supplied through a residual
current device (RCD) having a rated residual operating current not exceeding 30 mA.
Electrical connections
Electrical connections must made by trained electricians in accordance with the guidelines and standards for low voltage
installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An
all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and
socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching
are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and
fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should
always be checked.
Installation instructions
Steam cooker
Construction type 60-381
J56A.113-0
26.11.11 WIMA
2
Installing
1. Place appliance in front of the niche and insert the mains plug.
2. Carefully slide appliance into the niche until it is flush with the front of the cabinets, ensuring that the mains cable is not pinched.
3. Open appliance door and fasten the sides from the front with the 4 enclosed screws S.
Installing with a second oven in the same niche
Installation
It is not possible to install the appliance above an extractor oven because of the extraction pipes that lead upwards.
If a second oven is installed in the same niche (above or below the appliance), use bracket set 60 W to support the upper
appliance.
Below the second oven Above the second oven
295
(567)
378
596
548
~85˚
=
=
50
min. 550
600
560–568
20
~45
548
S
S
X
374
Detail X
374
Niche
378
Appliance
560–568
50
EURO 594
SMS 762
EURO 380
SMS 381
EURO 974
SMS 1143
W
min. 550
560–568
EURO 600
SMS 762
EURO 374
SMS 381
EURO 974
SMS 1143
min. 550
50
W
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
V-ZUG 58A Installation guide
-
V-ZUG MWHSL60 Installation guide
-
V-ZUG 28A Installation guide
-
-
-
-
-
-
Whirlpool MWC-XSL/60 Mirror Installation guide
-