Dell PowerEdge R210 User guide

Information Update

eSATA Device and Software RAID Solutions

Booting from an eSATA device is not supported when the system

is set to RAID mode with software RAID PERC S100 enabled.

eSATA does not support hot-swapping in ATA mode.

The following table lists the eSATA device options under different SATA

controller modes.

Software RAID PERC S100/S300 is not supported on the following

Windows

®

-based operating systems.

NOTE: Software RAID PERC S100/S300 is not supported on Linux-based operating

systems.

Mode Bootable Hot-Swappable

ATA Yes No

AHCI Yes Yes

RAID (S100 enabled) No No

Operating System Edition

Microsoft

®

Hyper-V™ Server

2008

Microsoft Windows Server

®

2008

with Hyper-V role enabled

Enterprise, Web, and Standard

Windows Server 2008 with SP2

with Hyper-V role enabled

Enterprise, Web, and Standard

Windows Server 2008 R2

with Hyper-V role enabled

Enterprise, Web, and Standard

September 2009

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Trademarks used in this text: Dell, and the DELL logo are trademarks of Dell Inc.; Microsoft, Windows,

Hyper-V, and Windows Server are either trademarks or registered trademarks of Microsoft Corporation

in the United States and/or other countries.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade

names other than its own.

Page is loading ...