2. Groen
  3. DL

Groen DL, D Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Groen DL Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
Rev. A
Revised 12/03
Part Number 146551
HINGED COVER KIT
For Models
D & DL
DL Model Shown
1. Remove hole plug caps using a flat-blade
screwdriver.
2. Align holes in riser bracket with holes in
trunnion pad.
3. Install mounting bolts, lock washers and
nuts to secure. Tighten to 20 ft.-lb. torque
with a 3/8” opened or socket wrench.
4. Align studs on actuator assembly to
holes in riser bracket.
5. Attach fender washer and nuts, but do not tighten.
6. Assemble actuator assembly to rear 3 dome cover
studs and secure using dome nuts. Tighten to 20 in.-lb.
torque with a 1/4” open end or socket wrench.
P/N 146551
NOTE: Apply Loctite® to all threaded fasteners during assembly.
7. Lower cover over kettle and adjust mounting bracket as required to align. Tighten the
four nuts below the actuator assembly to 10 ft.-lb. with a 1/4” open end or socket wrench.
8. Apply Loctite® to the cover studs.
9. Install handle spacers over front two
dome cover studs.
10. Attach handle over spacers and secure with dome
nuts.
1055 Mendell Davis Drive
Jackson, MS 39272
Telephone 601 372-3903
Fax 601 373-9587
D & DL HINGED COVER KIT
Part Number 146551
Rev. A, Revised 12/03
11. Tighten nuts to 20 in.-lb. with a 1/4”
open end or socket wrench.
12. Adjust tension in actuator assembly
by turning adjusting nuts. Use two 3/4”
open end wrenches.
13. Completed assembly should look like the photo above.
Loctite® is a registered trademark of the Henkel Loctite Corporation.
/