Finger-Holder-Stand
Suitable for all smartphones (also suitable for tablets)
A great solution to keep your smartphone dropsafe!
Instructions manual
This product is intended solely for the use on smartphones and tablets.
Attach:
Tip: The positioning of the product on the back of your smartphone or tablet for optimal handling depends on
several factors, such as the size of the mobile device or the size of your hand. Before final attaching, try the best
position by keep hold the product on the mobile device and indicated handling.
1. Remove the protective film from the adhesive surface of the product.
2. Apply the product to the desired position on the back of your smartphone or tablet and press it firmly.
Remove:
Remove the product from the side as shown. Forcible removal from above can damage the surface of your mobile
device.
Be careful upon removal to avoid adhesive residue. Should there remain stick some glue residue on the
smartphone or tablet, remove it with a damp cloth (please also note the manufacturer's care instructions of the
smartphone or tablet).
Would you keep the product for later use, cover the adhesive surface for protection against drying and dust with
the protective film or commercial cling film.
Clean:
Clean the surface of the product with a damp cloth. Omit the sticky surface. Do not use abrasive cleaners and
solvents.
Precautions
Do not subject the product to excessive shock or extreme force.
Do not hang heavy objects on the product.
Do not expose the product to extreme cold, high temperatures, direct sunlight or dust.
Do not immerse the product in water or other liquids.
Avoid contact with any corrosive materials.
Do not tamper any components of this product.
Keep the product out of reach of children. Risk of injury!
For damage on the product or on the mobile device caused by improper use, the manufacturer accepts no
liability.
Using the product on the protective film or cover of your mobile device is recommended.
/
