FlowerHouse FHBFB06 Operating instructions

BUTTERFLY BENCH INSTRUCTION

Preferred tools required are a 1/2" closed end wrench and 1/2" ratchet for body

wings and Seat, and 9/32" closed end wrench and 9/32" ratchet for antenna

assembly.

Step 1: Start by bolting wings to butterfly body (do not fully tighten until all

fasteners are in place on entire bench).

Step 2: Place seat in position and start fasteners (do not fully tighten until all

fasteners are in place on entire bench).

Step 3: Place antenna in position and start fasteners.

Step 4: Snug nuts and bolts gradually by moving from fastener location on body,

wings, seat and antenna with ratchet and closed end wrench.

Step 5: Once the fasteners are consistently tightened then your Butterfly Bench is

ready to be used as a bench.

BUTTERFLY BENCH INSTRUCTION

Preferred tools required are a 1/2" closed end wrench and 1/2" ratchet for body

wings and Seat, and 9/32" closed end wrench and 9/32 " ratchet for antenna

assembly.

Step 1: Start by bolting wings to butterfly body (do not fully tighten until all

fasteners are in place on entire bench).

Step 2: Place seat in position and start fasteners (do not fully tighten until all

fasteners are in place on entire bench).

Step 3: Place antenna in position and start fasteners.

Step 4: Snug nuts and bolts gradually by moving from fastener location on body,

wings, seat and antenna with ratchet and closed end wrench.

Step 5: Once the fasteners are consistently tightened then your Butterfly Bench is

ready to be used as a bench.

This manual is also suitable for

Download PDF