STEP 1
STEP 2
Assembly Instructions 2/4
Attach Support to Side Panel (E) with Wood Screws
into the pre-drilled holes. (See Figure 1)
Attach Base (D) and Side Panel (E)
to Back Panel (C), then flip the Locks.
(See Figures 2 and 3)
D
E
Figure 2
Figure 1
Figure 3
C
Attach Divider (G) to unit,
then flip the Locks.
Slide Bottom (H) into position.
Wood Screw
IMPORTANT
* Do not tighten all the Head Cap Bolts until the entire unit is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten the
Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
G
H