Rocking Chair
CAUTION : This Chair is NOT a TOY. Keep your child / children at bay in the
process of assembly.
For turning / flipping the chair and to prevent damage to the chair, 02 persons
may be needed to execute this action.
CAUTION: You must read this before you proceed.
1 of 6
Read instructions, cover to cover.
Have 2 adults on hand for assembly.
Do not assemble on flooring or carpet.
Assemble on a clean non-marring surface (packing foam).
Save all packaging until finished.
3
3
3
3Long Bolts M6x80
Sleeve Nut M6x15
Allen Key
j
k
Description
1
n
o
Long Screw M6x80
l
m
Short Screw M6x50
Short Bolts M6x65
Right Leg
Backrest
Seat Panel
DescriptionPictureNo. Qty
Qty
Before Beginning Assembly:
No. Picture
3
2
1
1
1
1
Seat Cushion
A
B
C
D
E
Left Leg
2 of 6
OVERVIEW
This Rocking Chair has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Rocking Chair parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions herebelow to familiarise the parts
and steps before assembly.
3 of 6
Step 2
Step 1
Step 2.1: Attach the Left leg (A) to the assembled frame as shown in picture. Then affix the Left leg (A)
with the Backrest (C) by using Long bolts (m), Slevee nut (n) and Allen Key (o).
Step 2.2: Affix the Left leg (A) with the end of Seat panel (D) by using Short bolt (l) and Allen Key
(o).
Step 2.3: Affix the Left leg (A) with the front of Seat panel (D) by using Long screw (j) and Allen Key
(o).
CAUTION : DO NOT FULLY TIGHTEN THE BOLTS/SCREWS
Attach the Backrest (C) into the housing on the Seat panel (D), then affix them by using Short screws
(k) and Allen key (o) as shown is picture.
CAUTION : DO NOT FULLY TIGHTEN THE SCREWS.
2.1
2.2
2.3
4 of 6
Turn the chair right way up.
NOW, go back to all screws and bolts previously loosely fasten, drive in and tighten all screws and
bolts in sequential manner.
This sequential manner will reduce possible distortion of frame.
Ensure that all screws and bolts are fully and securely tightened into wood.
Place the Seat Cushion (E) using the velcro straps, as shown in diagram.
This Rocking chair is ready for use.
Step 3
With the help from your partner, turn the chair to rest on Left leg (A).
Repeat same process as Step 2 to attach Right leg (B) into assembled frame as shown in picture.
CAUTION : DO NOT FULLY TIGHTEN THE BOLTS/SCREWS
Step 4
5 of 6
6 of 6
/
