HeatTrak HR-Therm3550 Installation guide

Category
Signal cables
Type
Installation guide
HeatTrak LLC
255 E 17
th
Street
Paterson, NJ 07524
www.HeatTrak.com
Operating Instructions for HeatTrak’s Thermostat Extension Cable
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
Operating Instructions:
This thermostat will automatically turn on your mats when the temperature drops below 35 degrees
(F). The Thermostat Extension Cable is simple to use. Plug one end directly into any 120V outlet and the
other end into your mat’s Power Unit. The Thermostat Extension Cable has an LED indicator that
illuminates when the thermostat is activated. It will remain activated until the ambient temperature
rises above 50 degrees (F).
Testing the Thermostat:
To test the thermostat, disconnect it from your outlet and Power Unit. Lay it on a flat surface and place
a bag of ice over the thick midsection for approximately 10 minutes (the part with the HeatTrak logo). By
doing this you will trick the thermostat into thinking it is cold outside and it will turn on. After 10
minutes plug the thermostat into an outlet and the LED indicator will illuminate so you will know it is
working.
  • Page 1 1

HeatTrak HR-Therm3550 Installation guide

Category
Signal cables
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI