Super Erecta Adjustable Undershelf Slides Assembly Instructions
TM
model numbers US18NA, US21NA, US24NA
Components:
Procedure:
Quantity
A. Undershelf Slide
B. Support Bracket
C. Slotted Screw, 8-32 x 1 1/4"
D. Lock Washer
E. Flat Washer
1. Confirm amount and identity of components as
shown above.
2. Determine the desired location of the tote box
under the shelf. Attach the slides as shown, by
hanging the support brackets on the support wires
with the support brackets facing in toward the
center of the shelf. Use the screws provided with
both lock washers and flat washers. Do not tighten
them all the way.
3. Try fitting the tote box into the slides and make
sure it will slide freely and that everything is aligned
properly.
4. Remove the tote box and tighten the screws.
5. Install the tote box.
2
4
4
4
4
North Washington Street, Wilkes-Barre, PA USA 18705
For Product Information, Call 1-800-433-2232
Information and specificationsare subject to change
without notice. Please confirmat time of order.
L01-074 rev. A 9/02
InterMetro Industries Corporation
Visit our Web Site: www.metro.com
A
B
C
D E
lock washer
flat washer
support wire
-
1
